-
221
Nanoparticle preparation of Mefenamic acid by electrospray drying
Published 2014“…Electrospray drying is a process that uses electrostatic force to disperse a conductive liquid stream into fine charged droplets through the coulomb fission of charges in the liquid and finally dry into fine particles. …”
Get full text
Get full text
Proceeding Paper -
222
Remote operation of CNC milling through virtual simulation and remote dekstop interface
Published 2009“…Capability of remote operation is supported by an auto setup attachment with a reconfigurable pin type setup free technology installed on the table of CNC milling machine to perform unattended machining process. …”
Get full text
Article -
223
Wear behavior of modified surface layer produced by TIG melting of preplaced Ti powder in nitrogen environment
Published 2011“…The wear property of the melt track was investigated using pin-on-disk tribometer at room temperature. The modified surface layer gave a low friction value of 0.12 and wear rate of 0.007895 ×10-4 compared to 1.648 × 10-4 mm3/N/m for the uncoated steel surface.…”
Get full text
Article -
224
Recovery of virus producing NDV vaccine by Tangential Flow Filtration (TFF)
Published 2009“…The results revealed that higher pressure input (Pin), lower pressure output (Pout), and higher virus concentration led to higher virus titer. …”
Get full text
Proceeding Paper -
225
Wear properties of Fe-C-Al cast iron and conventional cast iron - a comparative study
Published 2011“…In the present study, the wear test was conducted on both conventional cast iron (CI) and Fe-C-Al cast iron using universal pin-on-disk (POD) machine. The wear track profile and damage surface were characterized using optical profilometer and scanning electron microscopy (SEM) respectively. …”
Get full text
Proceeding Paper -
226
Microelectrical mechanical systems switch for designing multi-band antenna
Published 2009“…Problem statement: In this study Microelectrical Mechanical System (MEMS) switches were proposed to design a reconfigurable/multi-band antenna to replaced PIN diode switches or semiconductor switches due to lower insertion losses, good isolation, much lower intermodulation distortion, and lower power consumption. …”
Get full text
Article -
227
Smart home control system design using internet of things based energy harvesting technology
Published 2024“…The objective of this research is to provide security for homeowners by facilitating fingerprints and PIN (Personal Identification Numbers) in entering the house, then in the event of a power outage, it activates the function of energy harvesting technology. …”
Get full text
Conference or Workshop Item -
228
Improved personalised data modelling using parameter independent fuzzy weighted k-nearest neighbour for spatio/spectro-temporal data
Published 2021“…The NeuCube architecture is a data processing architecture for spatio/spectro-temporal data which consists of four main modules: a spike encoding module, a recurrent SNN reservoir, an output module, and an optimization module. …”
Get full text
Get full text
Get full text
Thesis -
229
Enhancement of oil palm empty fruit bunch char by impregnation of pyrolytic carbon from tar vapor decomposition
Published 2016“…Tar vapor was obtained from fast pyrolysis of fine EFB particles at 400–700°C, and the weight ratio of fine EFB particles—the tar source—to char substrate was increased from 0.5 to 4.0. …”
Get full text
Get full text
Get full text
Article -
230
Effects of simple abrasive combing and pretreatments on properties of pineapple leaf fibers (PALF) and PALF-Vinyl ester composite adhesion
Published 2010“…In pineapple leaves, PALF are present in top lamina as large vascular bundles and bottom lamina as fine strands. Tensile strength and modulus of fine PALF strands are 155% and 134% higher than those of vascular bundles respectively. …”
Get full text
Get full text
Article -
231
-
232
Utilization of Silica Fume and Sodium Hydroxide in Treated Crumb Rubber for Cement Mortar
Published 2024“…Cement mortar offers an excellent replacement for materials such as fine aggregate with tire rubber waste in the form of crumbs. …”
Get full text
Article -
233
The effect of palm oil diesel fuel contaminated lubricant on sliding wear of cast irons against mild steel
Published 1996“…This was done on three types of cast iron, namely spheroidal graphite, flake graphite and chilled cast iron against a mild steel disc configuration using a pin-on-disc type of friction and wear apparatus. …”
Get full text
Article -
234
Virtual simulation and remote desktop interface for CNC milling operation
Published 2011“…Capability of remote operation is supported by an auto setup attachment with a reconfigurable pin type setup free technology installed on the table of CNC milling machine to perform unattended machining process. …”
Get full text
Article -
235
Substrate integrated waveguide cavity backed frequency reconfigurable antenna for cognitive radio applies to internet of things applications
Published 2019“…Reconfiguration of frequency bands is achieved using PIN diodes. The antenna resonated at 2.624, 2.664, 2.720, 2.752, 4.304, 4.532, 4.556, 5.236, 5.304, 5.368, 5.332, and 5.392 GHz. …”
Get full text
Article -
236
-
237
A Systematic Review of the Concrete Durability Incorporating Recycled Glass
Published 2023“…However, up to 20% GP and up to 30% fine glass aggregate (FGA) could be replaced with cement and aggregate, respectively, to achieve a positive effect on durability based on the W/C ratio provided, not compromising the strength.…”
Get full text
Article -
238
A Systematic Review of the Concrete Durability Incorporating Recycled Glass
Published 2023“…However, up to 20% GP and up to 30% fine glass aggregate (FGA) could be replaced with cement and aggregate, respectively, to achieve a positive effect on durability based on the W/C ratio provided, not compromising the strength.…”
Get full text
Article -
239
Mechanical properties of concrete containing POFA and EPS as replacement materials
Published 2021“…To solve the problems of increase in amount of the oil palm waste and expanded polystyrene, high emission of carbon dioxide and high density or normal concrete, a research of replacing cement and fine aggregate with expanded polystyrene (EPS) and palm oil fuel ash (POFA) were done. …”
Get full text
Article -
240
Optimizations and recycling industrial waste (palm oil fly ash) as a pigment in coating technology
Published 2017“…The sintered product was milled and become grayish fine powder pigment. From the SEM images, the grain size approximately 0.404 µm. …”
Get full text
Get full text
Get full text
Thesis