Showing 2,321 - 2,340 results of 7,196 for search '(((sspina OR spina) OR five) OR ((((ching OR thin) OR pin) OR (spinge OR wong)) OR eng))', query time: 0.12s Refine Results
  1. 2321

    Utilisation of Backscattered Gamma Photons in Tc-99m SPECT Imaging by Sayed, Inayatullah Shah, Leeman, Sidney, Tonge, Christine M

    Published 1998
    “…In the work reported here, data straddling the 81-154 keV range were segmented into three disjoints energy windows: photopeak, backscaterring, and angle-scattered regions. …”
    Get full text
    Article
  2. 2322

    Development of International Islamic University Malaysia-Micro Aerial Vehicle (IIUM-MAV) by Omar, Ashraf Ali, Cheong, Zi Jian

    Published 2009
    “…The span dimensions for the IIUM-MAV6 and -MAV7 were, 1 m and 0.5 m, respectively. The total weight of MAV6 is 197 grams, while MAV7 is 157 grams. …”
    Get full text
    Proceeding Paper
  3. 2323

    A new study to suppress mutual-coupling between waveguide slot array antennas based on metasurface bulkhead for MIMO systems by Alibakhshikenari, Mohammad, Virdee, Bal Singh, Khalily, Mohsen, See, Chan, Abd-Alhameed, Raed, Falcone, Francisco, Limiti, Ernesto

    Published 2018
    “…WSA antennas used in the study has dimensions 40×20×5mm3 and operates over 1.7-3.66 GHz, which corresponds to a fractional bandwidth of 73.13%. …”
    Get full text
    Conference or Workshop Item
  4. 2324

    Energizing an IoT sensor using regenerative opposite fringing fields from an embedded communicating patch antenna by Kumar, Sundeep, Kumar, Manoj, Sharma, Ashwani, Garcia Zuazola, Ignacio Julio

    Published 2024
    “…The design proposes a proximity-coupled feed to the radiative circular patch for Wireless Information Transfer (WIT) in 5.7GHz - 6.0GHz band and an integrated capacitive-coupled feeding network, with full-wave rectification (FWR) using regenerative opposite fringing fields from the radiating edges of the patch for energizing IoT sensors by means of wireless power transfer (WPT) at 5.2GHz . …”
    Get full text
    Article
  5. 2325
  6. 2326
  7. 2327

    Performance Improvement of a Savonius Wind Turbine using Wavy Concave Blades by Mohanad Al-Ghriybah, Mohanad Al-Ghriybah, Djamal Hissein Didane, Djamal Hissein Didane

    Published 2023
    “…The simulation outcomes confirmed that the Cp of the wavy rotor increased by about 14.5% at a tip speed ratio of λ= 0.4. Additionally, outcomes showed the peak Cp is 0.18 at λ=0.7 which is 12.5% greater than the conventional SWT.…”
    Get full text
    Article
  8. 2328

    Frequency Response Analysis for Three-Phase Star and Delta Induction Motors: Pattern Recognition and Fault Analysis Using Statistical Indicators by Salem Mgammal Al-Ameri, Salem Mgammal Al-Ameri, Zulkurnain Abdul-Malek, Zulkurnain Abdul-Malek, Ali Ahmed Salem, Ali Ahmed Salem, Zulkarnain Ahmad Noorden, Zulkarnain Ahmad Noorden

    Published 2023
    “…In this regard, experimental measurements using FRA are performed on three IMs of ratings 1 HP, 3 HP and 5.5 HP in normal conditions, short-circuit fault (SC) and open-circuit fault (OC) conditions. …”
    Get full text
    Article
  9. 2329

    Influences of ambient temperature, injection pressure and spray characteristics on ignition delay and combustion process of palm oil and waste cooking oil by Nursal, Ridwan Saputra, Jaat, Norrizam, Khalid, Amir, Ishak, Izuan Amin, Zainal Abidin, Shaiful Fadzil, Manshoor, Bukhari, Samion, Syahrullail

    Published 2024
    “…Palm and waste cooking oil biodiesel blends fuel were produced by blending these oils with Euro5 pure diesel at concentration of 5vol%, 10vol% and 15vol% correspondingly. …”
    Get full text
    Conference or Workshop Item
  10. 2330

    Influences of ambient temperature, injection pressure and spray characteristics on ignition delay and combustion process of palm oil and waste cooking oil by Nursal, Ridwan Saputra, Jaat, Norrizam, Khalid, Amir, Ishak, Izuan Amin

    Published 2024
    “…Palm and waste cooking oil biodiesel blends fuel were produced by blending these oils with Euro5 pure diesel at concentration of 5vol%, 10vol% and 15vol% correspondingly. …”
    Get full text
    Conference or Workshop Item
  11. 2331

    Influences of ambient temperature, injection pressure and spray characteristics on ignition delay and combustion process of palm oil and waste cooking oil by Nursal, Ridwan Saputra, Jaat, Norrizam, Khalid, Amir, Ishak, Izuan Amin, Zainal Abidin, Shaiful Fadzil, Manshoor, Bukhari, Samion, Syahrullail

    Published 2024
    “…Palm and waste cooking oil biodiesel blends fuel were produced by blending these oils with Euro5 pure diesel at concentration of 5vol%, 10vol% and 15vol% correspondingly. …”
    Get full text
    Conference or Workshop Item
  12. 2332

    Behaviour of steel fiber reinforced concrete slab due to volume fraction of fiber by Shahidan, Shahiron

    Published 2009
    “…In this investigation,finite element simulation will be used to analyze the normal reinforced concrete slab and steel fiber reinforced concrete slab due to diffrent percentage of volume fraction with 1%, 1.5%, 2%, 2.5% and 3%. Through this simulation, the loading is applied and analyzed by the increments of every 2 KN up to ultimate failure. …”
    Get full text
    Thesis
  13. 2333

    Formulation and characterization of resiquimod microsponges loaded gel by Ab. Hadi, Hazrina, Zaiter, A., Awadh, Ammar Ihsan Jawad

    Published 2015
    “…Microsponges prepared by 2.5 mL of DCM, 1 mL of chloroform or 5 mL of EA in the dispersion phase were selected and coded as F1, F2 and F3. …”
    Get full text
    Article
  14. 2334

    Crystallization of N-terminal Strep-tagged Fusion Lipase from Thermostable Bacillus sp. Strain 42. by Basri, Mahiran, Raja Abd Rahman, Raja Noor Zaliha, Tengku Abdul Hamid, Tengku Haziyamin, Salleh, Abu Bakar

    Published 2009
    “…The purified fusion lipase, at protein concentration of about 4.0 mg/mL, was induced to crystallize in 0.1 M MES buffer at pH 6.5 without the presence of salt, but in the presence of only 12% w/v PEG 20 000 as precipitant. …”
    Get full text
    Article
  15. 2335

    Thyroid disorders, etiology and prevalence by Khattak, Muhammad Muzaffar Ali Khan, Khan, Alam

    Published 2002
    “…In Pakistan, the prevalence of hyperthyroidism and sub clinical hyperthyroidism was 5.1 and 5.8%, respectively. Similarly, the prevalence of hypothyroidism and sub clinical hypothyroidism was 4.1 and 5.4%, respectively. …”
    Get full text
    Article
  16. 2336

    Additive strategies to mitigate humidity interference effects on PEDOT:PSS sensors for ammonia detection by Beniwal, Ajay, Ganguly, Priyanka, Khandelwal, Gaurav, Gond, Rahul, Rawat, Brajesh, Li, Chong

    Published 2025
    “…This was a marked improvement over the pristine PEDOT:PSS sensor, which recorded 118.5% at the same humidity level, and outperformed other additive variants. …”
    Get full text
    Article
  17. 2337
  18. 2338

    Optimizing strength of directly recycled aluminum chip-based parts through a hybrid RSM-GA-ANN approach in sustainable hot forging by M. Altharan, Yahya, Shamsudin, Shazarel, Lajis, Mohd Amri, Sami Al-Alimi, Sami Al-Alimi, Yusuf, Nur Kamilah Y, Mohammed Alduais, Nayef Abdulwahab, Atef M. Ghaleb, Atef M. Ghaleb, Wenbin Zhou, Wenbin Zhou

    Published 2024
    “…Maximum UTS (237.4 MPa) was achieved at 550˚C, 120 minutes and 15.4 mm2 /mm3 of chip’s AS: V. The Tp had the largest contributing effect ratio on the UTS, followed by HT and AS:V according to ANOVA analysis. …”
    Get full text
    Article
  19. 2339

    Optimizing strength of directly recycled aluminum chip-based parts through a hybrid RSM-GA-ANN approach in sustainable hot forging by M. Altharan, Yahya, Shamsudin, Shazarel, Lajis, Mohd Amri, Al-Alim, Sami, Yusuf, Nur Kamilah, Mohammed Alduais, Nayef Abdulwahab, M. Ghaleb, Atef, Zhou, Wenbin

    Published 2024
    “…Maximum UTS (237.4 MPa) was achieved at 550˚C, 120 minutes and 15.4 mm2 /mm3 of chip’s AS: V. The Tp had the largest contributing effect ratio on the UTS, followed by HT and AS:V according to ANOVA analysis. …”
    Get full text
    Article
  20. 2340

    Optimizing strength of directly recycled aluminum chip-based parts through a hybrid RSM-GA-ANN approach in sustainable hot forging by M. Altharan, Yahya, Shamsudin, Shazarel, Lajis, Mohd Amri, Al-Alimi, Sami, Yusuf, Nur Kamilah, M. Ghaleb, Atef, Zhou, Wenbin

    Published 2024
    “…Maximum UTS (237.4 MPa) was achieved at 550˚C, 120 minutes and 15.4 mm2 /mm3 of chip’s AS: V. The Tp had the largest contributing effect ratio on the UTS, followed by HT and AS:V according to ANOVA analysis. …”
    Get full text
    Article