-
1261
-
1262
-
1263
Hybrid Optimization with Enhanced QoS-based Path Selection in VANETs
Published 2023“…Due to these characteristics, link failures occur, and delay and routing overhead is greatly increased, directly affecting the effectiveness, Quality of Service (QoS), and stability of VANETs. …”
Get full text
Article -
1264
Correlation analysis on crash factor in Surabaya-Manyar toll road
Published 2024“…Surabaya-Manyar Toll Road has been the main link between Surbaya and Jakarta since 1993. There were 149 crashes between 2014 and 2018, with seven fatalities. …”
Get full text
Conference or Workshop Item -
1265
Influence of Eu3+ Ions on Elastic Moduli and Microhardness of Zinc‑boro‑soda‑lime‑silica Glass System
Published 2024“…Poisson’s ratio of the samples signifes their low cross-link density behavior. Moreover, the ZBS-3Eu presents the highest microhardness value of 4.776 GPa. …”
Get full text
Article -
1266
A Review of Unmanned Aerial Vehicles/Urban Air Mobility Potential Cyberattacks and Authentication Models: A Way Forward
Published 2024“…The elements onboard use a network of sensors to communicate with GCS via a wireless link and thus make the system susceptible to various cyber-attacks. …”
Get full text
Article -
1267
-
1268
Critical point study in the Sabah power grid for cascading failure blackouts
Published 2014“…Sabah System Grid is made up of 66kV, 132kV and 275kV which link up all major towns in Sabah and Federal Territory of Labuan. …”
Get full text
Get full text
Thesis -
1269
Modeling and simulation of standalone hybrid PV-wind renewable energy system base case study: Iraq
Published 2019“…The end of the project are proposed a hybrid modeling of both the PV and the wind systems by using DC link using Matlab 2017b Simulink software. The case study suffer huge shortage of electrical power production. …”
Get full text
Get full text
Get full text
Thesis -
1270
-
1271
Comparison of surface roughness in end milling of titanium alloy Ti-6Al-4V using uncoated WC-Co and PCD inserts through generation of models
Published 2011“…They developed contours to select a combination of cutting speed, and feed without increasing the surface roughness. Fuh and Wang [9] developed a model for predicting milling force model in end milling operation. …”
Get full text
Book Chapter -
1272
Toxic species and particulate emissions from synthetic polymer fires
Published 2024Get full text
Thesis -
1273
-
1274
-
1275
-
1276
Core power control analysis and design for triga nuclear reactor
Published 2023Get full text
Thesis -
1277
-
1278
Effect of chromium (cr) particle size and span-20 surfactant on Aisi d2 hardened steel using electrical discharge machining
Published 2020“…Therefore, Powder Mixed Electrical Discharge Machining (PMEDM) has emerged as one of the advanced and innovative technique to eliminate the some of the disadvantages of EDM method. The fine powder particles are added into the tank then the spark gap is filled up with these additives particles. …”
Get full text
Get full text
Get full text
Thesis -
1279
Performance of composite sand cement brick containing recycled concrete aggregate and waste polyethylene terepthalate
Published 2018“…Moreover, the size of the sieved waste PET granules was between 0.1 to 5 mm which made it physically similar to the size of fine aggregates. The bricks were cast in moulds measuring 215 mm in length, 103 mm in width, and 65 mm in depth. …”
Get full text
Get full text
Get full text
Thesis -
1280