-
161
NTU e-bike
Published 2011“…To support the touchscreen, the expansion board pin configurations are modified according to the schematic connections, also the kernel changed to detect the GPS device, the Éclair system can‟t get GPS information directly since a hardware abstraction layer (HAL) is needed for interacting between the Android framework and the kernel. …”
Get full text
Final Year Project (FYP) -
162
CRISPR-DBA: a deep learning framework for uncertainty quantification of CRISPR off-target activities
Published 2024Conference item -
163
Ohmic contact formation to β-Ga2O3 nanosheet transistors with Ar-containing plasma treatment
Published 2024“…With the optimal plasma pre-treatment (i.e., Ar plasma, 100 W, 60 s), the resulting β-Ga2O3 nanosheet field-effect transistors (FETs) show effective Ohmic contact (i.e., contact resistance RC of 104 Ω·mm) without any post-annealing, which leads to competitive device performance such as a high current on/off ratio (>107), a low subthreshold swing (SS, 249 mV/dec), and acceptable field-effect mobility ((Formula presented.), ~21.73 cm2 V−1 s−1). …”
Get full text
Journal Article -
164
Analog smart I/O pads
Published 2009“…ESD is an increasingly significant problem in integrated circuit design as increasing pin counts and faster circuit speeds compound the need for more and better reliable ESD protection. …”
Get full text
Final Year Project (FYP) -
165
Tribological properties of wax microcapsule modified polymers
Published 2013“…The tribology test uses the Pin-On-Disk wear test method and the default tribometer settings used in this project were set at 2000m sliding distance, 40cm/s linear speed and 3N linear load. …”
Get full text
Final Year Project (FYP) -
166
Effect of emulsion temperature on physical properties of palm oil‐based margarine
Published 2002“…The emulsion temperatures studied were 40, 45, and 50°C, with other parameters such as emulsion flow rates, tube cooler temperature, and pin rotor speed kept constant. The SFC developed during processing and storage at 28°C was measured to evaluate the quality of margarine. …”
Get full text
Article -
167
InAlN/GaN high electron mobility transistors on Si for RF applications
Published 2018“…A thin layer of oxide between the metal gate and the thin InAlN barrier and form a metal-insulator-semiconductor (MIS) gate in the Planar nanostrip-channel GaN HEMT, gate leakage current was reduced and thus increase the gate voltage swing and drain current swing. The results show that the Planar nanostrip-channel Al2O3/InAlN/GaN MISHEMTs is able to work at up to Vg = +4 V and the linearity performance was further improved. …”
Get full text
Get full text
Thesis -
168
Fabrication of heat sinks by Selective Laser Melting for convective heat transfer applications
Published 2021“…Three heat sinks comprising pin fins of circular, rectangular-rounded and aerofoil geometries were fabricated by SLM from aluminium alloy AlSi10Mg powder. …”
Get full text
Journal Article -
169
A Novel MIMO antenna integrated with a solar panel and employing AI-equalization for 5G wireless communication networks
Published 2024“…We demonstrate that the directivity of this antenna array can be precisely electronically reconfigured using PIN diode switches. Additionally, we show the feasibility of integrating solar panels with the proposed MIMO antenna array. …”
Get full text
Get full text
Article -
170
-
171
Organic donor-acceptor cocrystals for multiferroic applications
Published 2021“…The cocrystallization strategy has provided an efficient route to fulfill room temperature magnetoelectricity in single phase owing to the long-range ordered π-π stacking (donor-acceptor assembled) network, long-lived excitons (with μs lifetime), spin orders (±1/2 s pin) and charge transfer (CT) dipoles in the assembled crystal lattice. …”
Get full text
Journal Article -
172
The Portevin-Le Chatelier effect of Cu-2.0Be alloy during hot compression
Published 2023“…As the strain rate increases, the dislocations outpace the diffusion speed of the solute atoms, limiting their ability to effectively pin the dislocations, resulting in lower dislocation density and serration amplitude. …”
Get full text
Journal Article -
173
Compatability and equilibrium approach to slender concrete column design (dual project)
Published 2017“…This report evaluates and compares the proposed design method with the Australian code AS3600-2001 for slender concrete column. The failure loads of pin-end columns under short term loading and uniaxial bending are used as a pre-determined factor to analyse the data. …”
Get full text
Final Year Project (FYP) -
174
Conformable ultrasound breast patch for deep tissue scanning and imaging
Published 2024“…The in vitro studies and clinical trials reveal that the array using a piezoelectric crystal [Yb/Bi-Pb(In <jats:sub>1</jats:sub> <jats:sub>/2</jats:sub> Nb <jats:sub>1/2</jats:sub> )O <jats:sub>3</jats:sub> -Pb(Mg <jats:sub>1/</jats:sub> <jats:sub>3</jats:sub> Nb <jats:sub>2/3</jats:sub> )O <jats:sub>3</jats:sub> -PbTiO <jats:sub>3</jats:sub> ] (Yb/Bi-PIN-PMN-PT) exhibits a sufficient contrast resolution (~3 dB) and axial/lateral resolutions of 0.25/1.0 mm at 30 mm depth, allowing the observation of small cysts (~0.3 cm) in the breast. …”
Get full text
Article -
175
Piezoelectric single crystal based one-dimensional phased array for breast tissue imaging
Published 2024“…In this thesis, I propose a conformable ultrasound breast patch (cUSBr-Patch) consisting of a one-dimensional (1D) phased array and a nature-inspired patch design, which offers large-area, deep tissue scanning and multi-angle, repeatable breast imaging while avoiding the drawbacks of conventional ultrasound imaging technologies. I used a Yb/Bi-doped PIN-PMN-PT single crystal as the active element due to its superior piezoelectric properties (d33 = 2,800 pC/N, εr = 7,000, k33 = 0.93). …”
Get full text
Thesis -
176
Two-phase immersion cooling for power dense printed circuit board converters
Published 2024“…A theoretical model and numerical solution method for boiling on pin fins is developed and used to design heat spreaders to increase the power dissipation per unit semiconductor area with minimal penalty on the converter volume. …”
Thesis -
177
Local-flexural interactive buckling of S690 high strength steel slender welded I-section columns: testing, modelling and design
Published 2022“…A testing programme, adopting two S690 high strength steel slender welded I-sections, was firstly conducted and included initial geometric imperfection measurements and ten pin-ended column tests. The testing programme was accompanied by a numerical modelling programme, where finite element models were developed and validated against the test results and then employed to perform parametric studies to generate further numerical data over a wide range of cross-section dimensions and member effective lengths. …”
Get full text
Journal Article -
178
High-voltage IR-UWB pulse generator MMIC design and beamforming for indoor-ranging and radar applications
Published 2020“…The presented design is fully utilizing the existing 2 µm GaAs HBT cascode pair configuration, which significantly increases the output voltage swing while reducing the total power consumption. …”
Get full text
Thesis-Doctor of Philosophy -
179
Development of advanced Fe-based oxygen carriers for chemical looping applications
Published 2024“…All the perovskite structured oxygen carriers showed excellent cyclic stability over pressure swing cycles at 500 °C, suggesting their suitability for long-term operation. …”
Get full text
Thesis-Doctor of Philosophy -
180
Human factors in agile software development
Published 2015“…• How does the developers' mood or team morale swing affect the task performing process and the quality of artifacts? …”
Get full text
Thesis