Search alternatives:
ceers » cheers (Expand Search), peers (Expand Search), beers (Expand Search)
beans » means (Expand Search), beams (Expand Search), beads (Expand Search)
teens » tens (Expand Search), beens (Expand Search), seens (Expand Search)
teen » been (Expand Search), seen (Expand Search), ten (Expand Search)
bear » year (Expand Search), near (Expand Search), beam (Expand Search)
bee » been (Expand Search)
ceers » cheers (Expand Search), peers (Expand Search), beers (Expand Search)
beans » means (Expand Search), beams (Expand Search), beads (Expand Search)
teens » tens (Expand Search), beens (Expand Search), seens (Expand Search)
teen » been (Expand Search), seen (Expand Search), ten (Expand Search)
bear » year (Expand Search), near (Expand Search), beam (Expand Search)
bee » been (Expand Search)
-
341
-
342
Digestibility of low-cost ingredients in pelleted feed by grass carp (Ctenopharyngodon idella C. et V.)
Published 1986“…In the MARDI feed, the fish meal and soya bean meal were digested most by the fish: the digestion coefficients for protein were 90.81% and 96.21%, respectively; for fat the values were 100% and 98.79%, respectively; and for gross energy the values were 83.37% and 82.71%, respectively. …”
Get full text
Article -
343
A study on consumers' perception of specialty coffee cafes
Published 2008“…For our research study, we have chosen Coffee Bean and Tea Leaf, Coffee Club, Spinelli Coffee Company, and Starbucks Coffee to be the subjects of our study on the basis of their popularity and size.…”
Get full text
Final Year Project (FYP) -
344
Prevalence of Listeria monoctogenes in foods in Malaysia
Published 1994“…The frequencies of L. monocytogenes contamination in raw foods were: chicken portions (60%), liver (60%) and gizzard (62%), beef (50%), beansprout (85%), prawns (44%), kupang (dried oysters) (33%), bean cake (25%), satay (48%) and leafy vegetables (22%). …”
Get full text
Article -
345
Minimal power manoeuvring techniques in nano-satellites
Published 2016“…The first idea focuses on moving a ball bearing in a tube while the second idea is about moving a ball bearing on a wooden board. …”
Get full text
Final Year Project (FYP) -
346
Stabilization/solidification of Mn-contaminated clay slurry by using CaO-GGBS: effects of anions
Published 2023“…Therefore, this study investigated the S/S efficiency of CaO-GGBS in treating MnSO4-bearing and Mn(NO3)2-bearing clay slurries. The effect of anions (i.e. …”
Get full text
Journal Article -
347
Determination of the local surface shapes on the foot surface from plantar view using surface curvature and colour scale for shape categories
Published 2008“…Two conditions of feet were scanned: weight bearing condition and non-weight bearing condition.…”
Get full text
Thesis -
348
Developing a web app in conjunction with a honey dehydrator
Published 2024“…Honey is a sweet tasting viscous liquid made by bees, and honey harvesting practices have grown in the last few decades. …”
Get full text
Final Year Project (FYP) -
349
Single view reconstruction of curved surfaces
Published 2006“…We increase modelling power in several ways: (i) We represent general 3D surfaces, rather than 2.5D Monge patches; (ii) We describe a closed-form method to reconstruct a smooth surface from its image apparent contour, including multilocal singularities ("kidney-bean" self-occlusions); (iii) We show how to incorporate user-specified data such as surface normals, interpolation and approximation constraints; (iv) We show how this algorithm can be adapted to deal with surfaces of arbitrary genus. …”
Conference item -
350
Instrumentation optimisation for unicompartmental knee replacement
Published 2024“…To minimise the risk of bearing fracture in the very long-term, surgeons should position the bearing close to the tibial wall, neutrally align the femoral component, and avoid using the thinnest Size 3 bearings in young patients.…”
Thesis -
351
Study on structural robustness to resist progressive collapse of vertical irregularly base-isolated structures
Published 2022“…It is suggested that reasonable protection measures should be set for the isolation bearing with greater vulnerability coefficient which may suffer from extreme accidents and the potential risk of isolation bearing with greater component importance coefficient is eliminated or reduced.…”
Get full text
Get full text
Article -
352
Study on mechanism and influential factors of progressive collapse resistance of base-isolated structure
Published 2022“…In the case of side isolation bearing failure, due to the lack of sufficient lateral restraint, the capacity was significantly lower than other conditions, which were more likely to cause partly collapse. …”
Get full text
Article -
353
Study of a dry fixed-vane revolving compressor
Published 2017“…However, when using sealed thrust bearings at the end-face and sealed roller bearings at the shaft-journal-support, results proved similar to lubricated values of power friction losses. …”
Get full text
Final Year Project (FYP) -
354
Influence of shear stress on cyclic behavior of marine sand
Published 2014“…Static and cyclic bearing capacity of marine soil is important for design of offshore wind turbine foundation. …”
Get full text
Get full text
Get full text
Journal Article -
355
Large-scale model testing of high-pressure grouting reinforcement for bedding slope with rapid-setting polyurethane
Published 2024“…This study proposes an innovative polymer grout method to improve the bearing capacity and reduce the displacement of bedding slopes. …”
Get full text
Journal Article -
356
IS activity in Southeast Asia
Published 2015“…The increasing number of recruits from Indonesia and Malaysia to Islamic State reflects the evolving security threat to Southeast Asia. The emerging pattern bears lessons for countries in the region.…”
Get full text
Get full text
Commentary -
357
Modeling of formation and breaking of lubricant bridge in the head–disk interface by molecular dynamic simulation
Published 2020“…And the duration of lubricant bridge is notably affected by heating-up time, rotation speed and bearing pressure. A shorter heating-up time leads to a longer duration of lubricant bridge, whereas a higher rotation speed and bearing pressure reduces the duration of lubricant bridge.…”
Get full text
Journal Article -
358
A 2'-alkynylnucleotide strategy for site-directed spin labelling of DNA
Published 2016“…Herein is also outlined the preparation of azide-bearing nitroxyl radicals. After site-selective incorporation of 2'-alkynylnucleosides into DNA using a standard solid-supported phosphoramidite protocol, the modified oligonucleotides were spin labelled with the azide-bearing nitroxyl spin labels via the Cu(I)-catalysed azide-alkyne [3+2] Huisgen cycloaddition (CuAAC or 'click' reaction). …”
Thesis -
359
Ratio-of-distance rigidity theory with application to similar formation control
Published 2021“…Its relations to three existing rigidity theories (distance, bearing, and angle rigidity theories) are established. …”
Get full text
Journal Article -
360
Azadihomocorannulene as a heptagon-embedded diradicaloid
Published 2025“…While diradical(oid) molecules bearing five-membered rings have been extensively investigated, those bearing seven-membered rings are relatively fewer. …”
Get full text
Journal Article