Heat transfer enhancement in drag-reducing channel flow by Yeo, Keng Hoo

“…In the present study, a two-dimensional water tunnel was designed and fabricated to investigate drag reduction by surfactant additives. Flow development check experiments were performed with different concentrations of surfactant additives to justify the fully developed flow conditions at the test section. …”
Get full text

Aerodynamic optimization and drag minimization for the ultra low cost UAV piquero aerodynamic by Liu, Hao

“…The third segment is a full simulation of the Piquero UAV to determine its lift and drag characteristics. …”
Get full text

Scaling of the velocity profile in strongly drag reduced turbulent flows over an oscillating wall by Skote, Martin

“…Scaling analysis of the velocity profiles in strongly drag reduced flows reveals that the slope of the logarithmic part depends on the amount of drag reduction (DR). …”
Get full text
Get full text

Capping layer enabled controlled fragmentation of two-dimensional materials by cold drawing by Chen, Ming, Li, Dong, Hou, Yuxin, Gu, Mengxi, Zeng, Qingsheng, Ning, De, Li, Weimin, Zheng, Xue, Shao, Yan, Wang, Zhixun, Xia, Juan, Yang, Chunlei, Wei, Lei, Gao, Huajian

“…Compared to the abundant phenomenological results from experiments, however, the underlying mechanisms of this technique are not fully explored. Here, supported by experimental investigation, finite element calculations, and theoretical modeling, we systematically study the effect of a capping layer on the controlled fragmentation of 2D materials deposited on polymer substrates during the cold drawing. …”
Get full text

Plastic Instability in Co-Cr-Ni-Mo alloy wires drawn with different drawing practices by GVK, Sai Srikanth, Tan, Ming Jen, Liu, Zhenyun

“…Plastic instability of Co-35Ni-20Cr-10Mo alloy was studied by inflicting the material to the different drawing process, namely Full Die Drawing (FDD) and Half Die Drawing (HDD). …”
Get full text

Determining the feasibility of a full-scale randomised controlled trial evaluating rehabilitation for people after acute patellar dislocation by Forde, C

“…This thesis aimed to determine if conducting this full-scale RCT was feasible.</p> <p>First, supervised (four to six physiotherapy sessions of tailored advice and exercise) and self-managed (one physiotherapy session that enabled self-management) rehabilitation interventions were developed, drawing on established intervention development approaches and frameworks.…”

Second life as a platform for virtual design and manufacturing by Wong, Raymond Tuck Wai.

Get full text

One day at a time. by Ho, Qi Yi.

“…Amongst the many misconceptions present is that those suffering from mental disorders will never fully recover from the illness, creating a highly problematic and prejudiced standpoint on the matter. …”
Get full text

The monsters under my bed : fears and phobias. by Chong, Cherlyn Peiwen.

Get full text

4.206 Introduction to Design Computing, Spring 2004 by Sass, Lawrence

“…The course focuses on teaching architectural design with CAD drawing, modeling, rendering and rapid prototyping. …”
Get full text

4.500 Introduction to Design Computing, Spring 2006 by Sass, Lawrence

“…Students design a small building using computer models leading to a full package of physical and virtual materials, from computer generated drawings to rapid, prototyped models.…”
Get full text

Wind tunnel testing of a ducted-fan unmanned aerial vehicle by Shiah, Zi Yang.

“…The experiments were carried out in a closed-loop wind tunnel with the full-scale MAV at different configurations. Coefficients of lift, drag and pitching moment were first discussed in a simple configuration of varying pitch angle with different wing setups without the propeller motor. …”
Get full text

Active control of wakes and vortex-induced vibration of a circular cylinder at Re = 100 by Wang, Chenglei

“…As zero net-mass-flux jets, SJs have been widely applied in flow separation control and drag reduction for bluff bodies. However, their implementation for VIV control is rare and still remains not fully understood. …”
Get full text

Information structure of subordinate clauses in Miriwoong by Sim, Michelle Jia En

“…Finally, paratactic clauses were found to 1) express sequential events or 2) draw a relation between two observations.…”
Get full text

Paint-your-mind : image creation for non-artists by Fang, Ran

“…Drawing or painting traditionally requires artistic skills and expertise – be it digital art or art forms of other mediums. …”
Get full text

Dwarf kingfisher-inspired bionic flapping wing and its aerodynamic performance at lowest flight speed by Mohd Firdaus Bin Abas, Singh, Balbir, Kamarul Arifin Ahmad, Ng, Eddie Yin Kwee, Khan, Tabrej, Sebaey, Tamer A.

“…The results show amplification of the maximum value for the cycle average lift and drag coefficient as the rotation angle increases. …”
Get full text

Publication of share recommendations in Lianhe Zaobao : testing for market response by Foo, Bin Gee, Tan, Tuan Kiong, Tan, Yin Hoon

“…Abnormal returns are also detected prior to the publication day, suggesting evidence that the market does not adjust instantaneously and fully upon the publication of the recommendations on the paper. …”
Get full text

Formal contracts mitigate social dilemmas in multi-agent reinforcement learning by Haupt, Andreas, Christoffersen, Phillip, Damani, Mehul, Hadfield-Menell, Dylan

“…It is an open problem in MARL to replicate such cooperative behaviors in selfish agents. In this work, we draw upon the idea of formal contracting from economics to overcome diverging incentives between agents in MARL. …”
Get full text

Effects of woven fabric embedment on thin film composite membranes for osmotically driven membrane processes (ODMPs) by Teo, Shino Yu Qin

“…While the technology itself shows potential, further advancement in ODMP membrane development is necessary to fully harness its power production capabilities. …”
Get full text

An experimental and simulation study of chip transportation behaviour in gundrilling by Tnay, Guan Leong

“…From the experiments, terminal velocities of typical gun drill chips at different range of particle Reynolds number were determined to construct the unique drag curve. Based on the findings, a computational fluid dynamic (CFD) numerical model was developed to predict the lateral drag forces with respect to the particle Reynolds number. …”
Get full text