Ultrasensitive metadevices for biosensing by Xiao, Shuqi

“…Relying on the structure, simulation has been done in Finite-difference Time-domain Simulation Software and the simulation result is collected and processed in Matlab and the simulation reveals good result of the metadevice. …”
Get full text

Accuracy of thoracolumbar pedicle screw insertion based on routine use of intraoperative imaging and navigation by Sundaram, Pirateb Paramasivam Meenakshi, Oh, Jacob Yoong-Leong, Tan, Mark, Nolan, Colum Patrick, Yu, Chun Sing, Ling, Ji Min

“…It is one of very few studies done on an Asian population with a large series of screws. …”
Get full text

Multi-criteria thermoeconomic and thermodynamic assessments of the desalination-integrated two-phase liquid-immersion data center cooling system by Kanbur, Baris Burak, Wu, Chenlong, Duan, Fai

“…The thermoeconomic assessment is done concerning the unique exergy-cost matrix of the original design. …”
Get full text

Optimizing selenization conditions of Cu2CdSn(S,Se)4 by Wong, Jia Mian

“…However, its efficiency is still significantly lower than existing thin film solar cells available in the market like Copper Indium Gallium Selenide (CIGS) and Cadmium Telluride (CdTe). Research has been done on selenizing CZTS forming Cu2ZnSn(S,Se)4 (CZTSSe) to further improve device’s efficiency by increasing grain size. …”
Get full text

A faster chemical bath deposition method for SnO2 ETLs in perovskite solar cells by Wong, Zi Sheng

“…Furthermore, device characterisations such as Scanning Electron Microscopy, Ultraviolet-visible spectroscopy and photoluminescence were done. Initial studies on the effect of pre-mixing sonication indicated positive device results, especially for a duration of 40 minutes. …”
Get full text

Active control of microdroplets by Tan, Elton.

“…An experiment at a higher flow rate of continuous phase flow rate was done, and a similar trend was spotted, although the droplet sizes did not vary as much as the lower flow rate. …”
Get full text

Reinforced concrete column design for minimal embodied carbon emissions by Siddiq Amsyar Bin Shalan

“…Although there are efforts that have been put into practise to minimize embodied carbon emissions, more can be done to further curtail carbon emissions in a systematic way that could guide structural engineers in their daily design tasks. …”
Get full text

Investigation of the fuel consumption of a ship considering the dynamic coupling effect among resistance, propeller torque and engine power under the control of a governor by Beh, Gerald Kah Hooi

“…Much research has been done on a ship in ideal conditions, that is, calm water conditions, constant ship speed and constant rate of revolutions of the diesel engine. …”
Get full text

Improved virtual keyboard design for P300-based brain-computer interface by Tay, Abel Ping Liang.

“…Word predictions and multiple letter flashing are currently disabled in order to integrate with the P300 interface. Integration has been done incrementally and tested at every stage. Steps that help toward integration include spacing the characters with a bigger gap on the screen, changing non-flashing colours to blend into the background and making the flashing character as contrasting as possible. …”
Get full text

Simulation of wind field in a building complex for evaluation of the wind effect along UAS flight path by Nathanael, Joshua Christian, Wang, John Chung-Hung, Low, Kin Huat

“…The wind simulation was done using various inlet wind speeds and directions based on the measurements from a weather station near the building complex. …”
Get full text

Time series anomaly detection by Lek, Jie Kai

“…In this paper, anomaly detection is done on a time series aero-engine dataset by implementing an autoencoder. …”
Get full text

Error analysis of a first-order IMEX scheme for the logarithmic Schrödinger equation by Wang, Li-Lian, Yan, Jingye, Zhang, Xiaolong

Get full text

Design and development of a biopolymer microfiber fabrication device by Yap, Yi-Liang.

“…One emerging approach is to reconstruct the tendon by Tendon Tissue Engineering (TTE). This is done by culturing cells on a biodegradable scaffold. …”
Get full text

Spatial aware information retrieval for community-based Q&A (SIRCQA) by Ang, Eugene Soon Leong

“…Although many researches has been performed for spatial aware retrieval on web documents, very little investigation has been done for CQA entries. Thus in this report, the techniques of Spatial Aware Retrieval were being analyzed to propose a suitable retrieval operation in Spatial Aware Information Retrieval for CQA, SIRCQ. …”
Get full text

几米的“寂寞文学” = Jimmy Liao's "Solitary literature" by 陈品馨 Tan, Pin Sing

“…His illustrations are done with adult readers in mind instead of children, pioneering the wave of adult illustrated books and resulting in a Jimmy Liao phenomenon.According to the book’s content, this thesis divided the theme “loneliness” into three different categories, namely “Lack of an understanding party”, “Love and longing” and “Cold and unconcerned city”. …”
Get full text

Membrane filtration - the effect of turbulence by Chong, Joseph Xuefeng

“…The purpose of the study was to gain a better understanding as to how turbulence could ultimately affect membrane fouling in terms of the parameters k, Ll and Lt. A correlation was done between the three different turbulence parameters and the rate at which fouling occurred (dTMP/dt). …”
Get full text

A study on the productivity evaluation of building information modelling (BIM) based prefabricated prefinished volumetric construction (PPVC) project by Fernandez, Priscilla Crystal

“…BIM based PPVC developments are still new in Singapore and therefore, more study needs to be done to evaluate the extent of productivity gains and the potential problems it brings about locally. …”
Get full text

Synthesis and self-assembly of plasmonic metal nanoparticles for surface-enhanced Raman scattering spectroscopy by Chew, Wee Shern

“…Using azo dye as a model reaction, we are able to detect bisphenol A up to 1 × 10-15 mole, improving its detection limit by 4 orders of magnitude compared to a SERS-based aptasensor platform. From the works done, we envision the diversification of hollow MNPs, benefiting from the generic synthesis method introduced, which can lead to new discoveries of optical or physical properties for tailored applications. …”
Get full text

DC fault detection and clearance in VSC-HVDC systems by Yeap, Yew Ming

“…For this study, it is entirely done in PSCAD/EMTDC.…”
Get full text

Fabrication of vascularized hydrogel construct through 3D printing by Neo, Frederik Wang Huang

“…It is an advanced field of research that currently takes advantage of 3D printing which itself has been touted as a revolutionary manufacturing method that possibly disrupts how manufacturing is viewed and done. The ability to convert a virtual model to a physical one through 3D printing has revolutionized and opened up a whole slew of new avenues in the manufacturing process of 3D scaffolds for tissue engineering purposes. …”
Get full text