-
21
-
22
Overview of Jute Fibre as Thermoplastic Matrix Polymer Reinforcement
Published 2024Get full text
Article -
23
-
24
High-gain metasurface in polyimide on-chip antenna based on CRLH-TL for sub-terahertz integrated circuits
Published 2020“…Concentric dielectric-rings are etched in the ground-plane under the radiation patches implemented on the top-layer. …”
Get full text
Get full text
Article -
25
Effect of adding global postural re-education to Kendall exercises for treating asymptomatic forward head posture: a single-blinded randomized controlled trial
Published 2025“…Conclusions: The added effect GPR technique to Kendall exercises significantly improved CVA, CROM, NDI, chest expansion, and spinal mobility in subjects with FHP.…”
Get full text
Article -
26
49 collected poems
Get full text
Get full text
Ephemera -
27
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
28
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
29
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
30
Biomedical Analysis of Lateral Lumbar Interbody Fusion (LLIF) Cage for Lumbar Vertebrae
Published 2023“…Objective: To develop the interbody cages implanted between the lumbar vertebrae by evaluating the strength of the bone model and the spinal cage. Materials and methods: In this study, finite element analysis (FEA) was applied using Mechanical Finder software (MF) to develop a 3D spine model lumbar vertebrae of the fourth and fifth lumbar vertebrae (L4 - L5) with various interbody cage designs, including honeycomb and rectilinear patterns with 50%, 70%, and 100% infill densities. …”
Get full text
Article -
31
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
32
Novel concentric hexagonal-shaped RFID tag antenna with T-shaped stub matching
Published 2022“…The rings are excited with a common microstrip feedline. …”
Get full text
Article -
33
Metamaterial inspired electromagnetic bandgap filter for ultra-wide stopband screening devices of electromagnetic interference
Published 2023“…The size and gap between the slit-rings dictate the magnitude of the reactive loading. …”
Get full text
Article -
34
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
35
Analysis re-entrant honeycomb auxetic structure for Lumbar vertebrae using finite element analysis
Published 2024“…Lumbar spinal fusion is a frequent surgical solution among people who are experiencing severe persistent lower back pain. …”
Get full text
Article -
36
Biomechanical evaluation and new improvement on ankle external fixator
Published 2023Get full text
Thesis -
37
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article -
38
Metasurface for controlling polarization of scattered EM waves
Published 2020“…The dual band metasurface is realized by stacking an array of multiple concentric circular rings. By rotating each array with respect to each other, we can manipulate its impedance at distinct frequencies. …”
Get full text
Conference or Workshop Item -
39
Photonic controlled metasurface for intelligent antenna beam steering applications including 6G mobile communication systems
Published 2023“…The metasurface layer is a lattice pattern of square framed rhombus ring shaped unit-cells that are interconnected by PIN photodiodes. …”
Get full text
Get full text
Article -
40
Measurement and modelling of operational amplifier power supply rejection
Published 1995“…Measured results for 741 and pin-compatible operational amplifiers are tabulated. …”
Get full text
Article