-
641
Investigation of the effects of machining parameters and air blowing on surface topography in high speed end milling of silicon
Published 2012“…The resultant surfaces were analysed using Optical and Scanning Electron Microscopes. Then, the influence of each machining parameter on surface roughness was investigated. …”
Get full text
Article -
642
Statistical approach to modeling & optimization of surface roughness in high speed end milling of silicon with diamond coated tools
Published 2012“…The resultant surfaces were analysed using Optical and Scanning Electron (SEM) Microscopes as well as Wyko NT 1100 and SurfTest SV-500 profilometers. …”
Get full text
Article -
643
Control of nozzle flow in a suddenly expanded duct with micro jets
Published 2012“…On the positive side the gain was 30 per cent whereas on the negative side the decrease in base pressure was 40 per cent. After scanning the wall pressure in the enlarged duct it is found that the wall pressure distribution is not adversely affected by the micro jets.…”
Get full text
Article -
644
Investigations into the effects of material filters (Cu 0.125mm and Al 0.2mm) on image linearity in Tc-99m SPECT
Published 2016“…SPECT data were collected by scanning Carlson’s phantom with the linearity insert. …”
Get full text
Article -
645
Comparison of Chang’s with Sorenson’s attenuation correction method by varying linear attenuation coefficient values in Tc-99m SPECT imaging
Published 2008“…Data are acquired with both the collimators either LEGP or LEHR by scanning R. A. Carlson cylindrical phantom over 360o with an acrylic block of holes simulating hot regions of various sizes at different locations with respect to the walls of the phantom,which was filled with water and Tc-99m solution was uniformly distributed. …”
Get full text
Get full text
Get full text
Book Chapter -
646
RF magnetron sputtered YSZ thin film: Fabrication and characterizations
Published 2010“…The deposited thin films thickness ranges from 300 nm to 2 μm as determined from the scanning electron microscopy. Phase analysis using the X-ray diffraction (XRD) revealed monoclinic, tetragonal and cubic phases of zirconia, and yttria peaks. …”
Get full text
Proceeding Paper -
647
First occurrence of Cochlodinium blooms in Sabah, Malaysia
Published 2008“…Identification of C. polykrikoides as the causative organism was based on light and scanning microscopy, and confirmed by partial 18S ribosomal DNA sequences of two strains isolated during the bloom event (GenBank accession numbers DQ915169 and DQ915170). …”
Get full text
Article -
648
A multi-beam circularly polarised Fabry-Perot resonator antenna array using SIW for X-Band applications
Published 2025“…II) show |S11| ≤ −10 dB between 8–12.0 GHz, a circular polarisation (CP) gain variation between 15.64–18.54 dBic, 3 dB axial-ratio between 8.5–11 GHz, and scanning angle covering −47 to 47 degrees.…”
Get full text
Article -
649
Development and evaluation of network utilities using Python for efficient management
Published 2024“…To this end, automated tools have been developed to handle various networking tasks such as port scanning, WHOIS retrieval, traceroute operations, subnet calculations, speed evaluations, router configurations, DNS resolutions, and IP verifications. …”
Get full text
Conference or Workshop Item -
650
An Approach to Automatic Garbage Detection Framework Designing using CNN
Published 2023“…The designed system named Greenlock scans and identifies entities that resemble an accumulation of garbage or a garbage dump in real time and alerts the respective authorities to deal with the issue by locating the point of origin. …”
Get full text
Article -
651
Effect of sintering temperatures on the physical, structural properties and microstructure of mullite-based ceramics
Published 2024“…Analysis through field emission scanning electron microscopy (FESEM) provided insights into microstructural changes, including alterations in grain morphology, porosity, and connectivity. …”
Get full text
Article -
652
An Approach to Automatic Garbage Detection Framework Designing using CNN
Published 2023“…The designed system named Greenlock scans and identifies entities that resemble an accumulation of garbage or a garbage dump in real time and alerts the respective authorities to deal with the issue by locating the point of origin. …”
Get full text
Article -
653
Stabilization of peat using sugarcane bagasse ash (SCBA) and cement as a stabilizer
Published 2023“…The microstructure of a sample of 100 PC with 15 PCBA that is hollow is reduced and becomes denser as a result of the filler material SCBA's reaction, as shown by a scanning electron microscope (SEM). The test Energy Dispersive X-Ray (EDX) with the lowered of carbon and calcium rise value shows the pozzolanic reaction. …”
Get full text
Conference or Workshop Item -
654
Surface properties of alginate/chitosan biofilm for wound healing application
Published 2020“…Then, the surface properties of the prepared biopolymer films were characterised via Field Emission Scanning Electron Microscopy (FESEM), Atomic Force Microscopy (AFM) and contact angle measurement. …”
Get full text
Conference or Workshop Item -
655
Photocatalytic degradation of phenol over visible light active ZnO/Ag2CO3/Ag2O nanocomposites heterojunction
Published 2018“…The synthesized photocatalysts were characterized by X-ray diffraction (XRD), BET specific surface area, field emission scanning electron microscopy (FESEM), transmission electron microscopy along with energy-dispersive X-ray (TEM-EDX), Fourier transform infrared (FTIR), UV-Vis-NIR spectrophotometer to reveal their phase, morphology, purity, and optical properties. …”
Get full text
Article -
656
Synthesis, characterisation and evaluation on the performance of ferrofluid for microplastic removal from synthetic and actual wastewater
Published 2021“…Subsequently, the physical and chemical properties of the prepared ferrofluid were also analysed using scanning electron microscope (SEM) and Fourier transform infrared (FTIR) spectroscopy. …”
Get full text
Article -
657
Physical ageing and thermal analysis of PLGA microspheres encapsulating protein or DNA
Published 2007“…PLGA microspheres undergo physical ageing but their ageing kinetics have not been reported, nor the effect of encapsulated protein or plasmid DNA on any associated changes to the glass transition. Differential scanning calorimetry (DSC) was used to measure the rate of ageing of various PLGAmicrosphere formulations, with temperature-modulatedDSCused to accurately measure the associated glass transition. …”
Get full text
Article -
658
Influence of electrode cooling on recast layers and micro crack in EDM of titanium
Published 2011“…The influence of cooling of copper electrode on recast layers and micro crack on titanium were investigated using scanning electron microscope (SEM) and has been reported in this study.…”
Get full text
Article -
659
Immobilization of cellulases enzyme on Carbon Nanotubes (CNTs) for cellulosic compounds degradation
Published 2010“…The morphology and the structure of CNTs were characterized by Field Emission Scanning Electron Microscopy (FSEM) and Fourier Transform Infrared Absorption Spectroscopic (FTIR). …”
Get full text
Proceeding Paper -
660
A review of focused ion beam sputtering
Published 2010“…The replicated microcomponents were inspected with scanning electron microscope where faithful duplication of accuracy and surface texture of the cavity was observed.…”
Get full text
Article