Showing 2,281 - 2,300 results of 10,648 for search '((pinnae OR (pine OR (fine OR five))) OR ((line OR (aina OR ainaa)) OR pin))', query time: 0.22s Refine Results
  1. 2281
  2. 2282
  3. 2283
  4. 2284
  5. 2285

    Tantalum based amorphous thin films as copper diffusion barrier by Yan, Hua

    Published 2013
    “…With the fast development of semiconductor industry, a novel barrier is required in order to address two challenges in the back-end-of-line technology: enhancing the interconnect reliability of back-end-of-line and reducing resistance-capacitance delay faced during further scaling of semiconductor devices. …”
    Get full text
    Thesis
  6. 2286

    Point defect–dislocation interactions in BEOL-compatible Ge-on-Si epitaxy by Postelnicu, Eveline, Wen, Rui-Tao, Ma, Danhao, Wang, Baoming, Wada, Kazumi, Michel, Jurgen, Kimerling, Lionel C

    Published 2024
    “…Hall effect measurements following post growth heat treatment between 400 and 600 °C reveal an acceptor removal reaction that follows first-order kinetics with an activation energy of 1.7 ± 0.5 eV and a pre-exponential factor of 2.3×107 s−1 consistent with a point defect, diffusion limited process. …”
    Get full text
    Article
  7. 2287

    Human machine interface/brain control for electric vehicles application by Tang, Tao

    Published 2018
    “…The AFE has obtained the smallest PEF under ultra-low power supply of 0.5 V with power consumption of 2 µW and a low input-referred noise of 2.1 µVrms that is achieved by high-frequency chopping scheme.…”
    Get full text
    Thesis-Doctor of Philosophy
  8. 2288

    Design of a conformal end-fire array antenna by Wang, Xin Xin

    Published 2015
    “…The newly proposed ridged SIW horn antenna consists of four layers: (i) ellipse-shaped copper taper with stepped ridge connecting to feed line; (ii) the first substrate layer of Duriod RT 5580 with permittivity of 2.2 and thickness of 0.508 mm; (iii) the second substrate layer of Teflon with permittivity of 2.1 and thickness of 5 mm; (iv) rectangular ground plane. …”
    Get full text
    Final Year Project (FYP)
  9. 2289

    Electrochemical scrutinizing techniques on initial development of pseudomonas aeruginosa strain (PAO1) biofilms by Foo, Yu Hao

    Published 2018
    “…There remains a need for precise on-line monitoring techniques that are wieldy and cost effective, to detect early biofilm establishment in real time. …”
    Get full text
    Final Year Project (FYP)
  10. 2290

    Additive quantization for truly tiny compressed diffusion models by Hasan, Adil

    Published 2024
    “…We are rewarded with state-of-the-art results on the important class-conditional benchmark of LDM-4 on ImageNet at 20 inference time steps, in- cluding sFID as much as 1.93 points lower than the full-precision model at W4A8, the best-reported results for FID, sFID and ISC at W2A8, and the first-ever successful quantization to W1.5A8 (less than 1.5 bits stored per weight). Furthermore, our pro- posed method allows for a dynamic trade-off between quantization-time GPU hours and inference-time savings, in line with the recent trend of approaches blending the best as- pects of post-training quantization (PTQ) and quantization-aware training (QAT), and demonstrates FLOPs savings on arbitrary hardware via an efficient inference kernel.…”
    Get full text
    Final Year Project (FYP)
  11. 2291

    Synthesis, Characterisation Of Stilbene–Arylcinnamide Hybrids And Cytotoxic Studies Against Lung Cancer Cell A549 by Mohd Zaki, Nurain Syazwani

    Published 2024
    “…The cytotoxicity against human lung cancer A549 cell line was assessed by the 3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium (MTT) assay, using cisplatin as the positive control. …”
    Get full text
    Thesis
  12. 2292

    Immobilization of cyclodextrin glucanotransferase on electrospun polyvinyl alcohol nanofibers by Saallah, Suryani

    Published 2014
    “…The microstructure of electrosprayed CGTase immobilised on PVA nanofibers was observed using SEM and the effectiveness of the two immobilisation approaches was compared in terms of enzyme loading, enzyme activity and reusability with enzyme concentration ranging from 1 to 7.5% v/v. Post-spinning deposition produced nanofibers with denser particles deposited on its surface, while uniform distribution of particles within the nanofibers was observed when simultaneous electrospraying and electrospinning was applied. …”
    Get full text
    Thesis
  13. 2293

    Low voltage low power output programmable OCL-LDO with embedded voltage reference by Nardi, Utomo, Teo, Terence Boon Chiat, Lim, Xian Yang, Venkadasamy, Navaneethan, Liu, Ziming, Tan, Chong Boon, Seah, Bryan Yun Da, Lam, Yvonne Ying Hung, Siek, Liter

    Published 2021
    “…Simulation results show that the line regulation is below 12.5mV/V, load regulation is below 2.6mV/mA and temperature coefficient (TC) is below 59ppm/ o C under all different output voltage modes of the LDO. …”
    Get full text
    Conference Paper
  14. 2294

    15.014 Applied Macro- and International Economics, Spring 2004 by Rigobon, Roberto

    Published 2004
    “… The course is divided in five parts: Basic tools of macroeconomic management Evaluation of different economic development strategies Crises in emerging markets: causes, solutions, and prevention Problems faced by transition economies Challenges of developed countries   This course is a full-term version of Applied Macro- and International Economics (15.012), with additional topics.…”
    Get full text
    Learning Object
  15. 2295

    Telemetry Fault-Detection Algorithms: Applications for Spacecraft Monitoring and Space Environment Sensing by Carlton, Ashley, Morgan, Rachel, Lohmeyer, Whitney, Cahoy, Kerri

    Published 2018
    “…In two satellites, the same top event date (4 December 2008) occurs over more than 10 years of telemetry from both satellites. Of the five spacecraft with known maneuvers, the algorithms identify the maneuvers in all cases. …”
    Get full text
    Article
  16. 2296
  17. 2297
  18. 2298

    Experimental study on mix proportion and fresh properties of fly ash based geopolymer for 3D concrete printing by Panda, Biranchi, Tan, Ming Jen

    Published 2019
    “…Extrudability, shape retention, buildability and thixotropic open time (TOT) are identified as critical early-age properties to characterize the 3D printable geopolymer material. Five different mix designs of geopolymer are tested in a systematic experimental approach to obtain a best printable mix and later it is used to print a 60-centimeter-tall freeform structure using a concrete gantry printer to validate the formulation.…”
    Get full text
    Get full text
    Journal Article
  19. 2299

    A novel ultra-low power two-terminal zener voltage reference by Kok, Chiang-Liang, Lim, Wei Meng, Siek, Liter

    Published 2013
    “…Experimental results, carried out on five different silicon samples, explicitly show that it can yield a stable output voltage of 0.22 V at room temperature. …”
    Get full text
    Get full text
    Get full text
    Journal Article
  20. 2300

    Personality and situational judgement tests of leadership effectiveness : the mediating effect of motivation to lead by Heng, Wen Jun

    Published 2020
    “…However, the past research in this domain is limited by the predominant use of the five-factor model to define personality (Extraversion, Agreeableness, Conscientiousness, Openness, and Neuroticism). …”
    Get full text
    Final Year Project (FYP)