-
41
-
42
-
43
Design optimization of valve timing at various engine speeds using Multi-Objective Genetic Algorithm (MOGA)
Published 2008Get full text
Proceeding Paper -
44
-
45
-
46
-
47
-
48
Overview of Jute Fibre as Thermoplastic Matrix Polymer Reinforcement
Published 2024Get full text
Article -
49
-
50
-
51
-
52
-
53
Influence of multisensory graviceptive information on the apparent zenith
Published 2010“…Experiment 1 involved rotation on a centrifuge and settings of the AZ. Subjects were supine on the centrifuge, and their body position was varied in relation to the rotation axis so that the gravitoinertial resultant force at the otoliths was 1 or 1.2 g with the otolith organs positioned 50 or 100 cm from the axis of rotation. …”
Get full text
Article -
54
-
55
Bio-fuel-contaminated lubricant and hardening effects on the friction and wear of AISI 1045 steel
Published 1998“…A study has been made on the wear and fiction of hardened AISI 1045 steel using a pi-pin-ondisc type of fiction and wear apparatus. During the investigation the linear pin wear, coe@cient of friction and rise in pin specimen temperature were monitored and wear and fiction curues 'plotted. …”
Get full text
Article -
56
Thresholds for vestibular-evoked myogenic potentials (VEMPs) produced by impulsive transmastoid acceleration.
Published 2013“…Design: VEMPs and OVEMPs were obtained simultaneously from subjects in supine posture with both head and eyes elevated. Thresholds to ITA were measured using four different response identification methods. …”
Get full text
Article -
57
Shear strength analysis of concrete beams reinforced with GFRP bars using strut and tie model
Published 2011“…The experimental approved that the spacing between shear cracks for the specimens with larger shear span to depth ratio is greater than the smaller shear span to depth ratio and while the shear span to depth ratio (a/d) decreases, the shear strength increase. …”
Get full text
Get full text
Get full text
Thesis -
58
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
59
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
60
Enrichment of fruit wastes with white rot fungi under submerged state bioconversion
Published 2013“…On Banana and Pineapple (BPin) the protein content were recorded as18.05 and 15.75 mg/g, which was higher than Papaya and Pineapple (PinPw) and Banana and Papaya (BPw)composite. M6 has 15.4 and 9.78 mg/g on BPinPw, 13.84 and 13.59 mg/g on BPw, 20.82, and 22.97 mg/g on BPin and 18.29 and 11.59 mg/g on PinPw. …”
Get full text
Proceeding Paper