Showing 301 - 320 results of 420 for search '((pinnau OR ((owing OR supinge) OR (shing OR shin))) OR (((span OR shingo) OR sshina) OR pin))', query time: 0.08s Refine Results
  1. 301

    Physical, mechanical and environmental properties of fired clay bricks incorporated with palm oil mill waste by Sarani, Noor Amira

    Published 2019
    “…Due to operational challenges and expensive operational cost, POMW is potentially incorporated into fired clay brick owing to high lignocellulosic characteristics. Therefore, this study aims to investigate the physical, mechanical and environmental properties of POMW such as palm kernel shell (PKS), palm oil fuel ash (POFA), palm fibre (PF) and empty fruit bunch (EFB) as a replacement material for brick making. …”
    Get full text
    Get full text
    Get full text
    Thesis
  2. 302
  3. 303

    A new three-phase 6-slots 10-poles permanent magnet flux switching machine with inner rotor configuration by Jenal, Mahyuzie

    Published 2021
    “…In this work, four topologies have been proposed, such as 6S-10P PMFSM with salient type of rotor (SalR), 6S-10P PMFSM with span rotor (SpR), 6S-8P AlCiRaF PMFSM with segmental rotor (SegR AlCIRaF) and 6S-10P AlCiRaF PMFSM with salient rotor (SalR AlCiRaF) are modeled and simulated using 2D-FEA JMAG v. 14.1 for the initial performance investigation. …”
    Get full text
    Get full text
    Get full text
    Thesis
  4. 304

    Shear strengthening and repair of deep beams with and without web reinforcement using near-surface mounted CFRP bars by Raheem Hassan, Douread

    Published 2018
    “…Each group of deep beams has the same shear span to effective depth ratio at 0.864. Group G1 consists of two beams as a control specimens and each one differs depending on either with web and without web reinforcement. …”
    Get full text
    Get full text
    Get full text
    Thesis
  5. 305

    Low velocity impact response of rc beam with artificial polyethylene aggregate as concrete block infill by M. Mustafa, Mohamed

    Published 2018
    “…Furthermore, the width of the cracks generated in the RCAI specimens near the mid-span was less than that on the NRC specimen. All experiment results were validated against FEM. …”
    Get full text
    Get full text
    Get full text
    Thesis
  6. 306

    Influence of workpiece preheating on chatter and machinability of Titanium alloy - Ti6Al4V by Amin, A. K. M. Nurul, Kamaruddin, K., Abdelgadir, M.

    Published 2011
    “…Though classified as a group of “difficult-to-cut” material, titanium and its alloys are have wide applications in the aerospace industry owing to their unique high strength-weight ratio which is maintained at elevated temperatures and their exceptional corrosion resistance. …”
    Get full text
    Book Chapter
  7. 307

    INFLUENCE OF MACHINING PARAMETERS ON TOOL WEAR AND MACHINING PERFORMANCE IN HIGH SPEED DUCTILE MODE END MILLING OF SODA LIME GLASS by Amin, A. K. M. Nurul, Konnek, Mohammed

    Published 2016
    “…Abstract: Soda lime glass is used extensively in engineering application owing to its high hardness, excellent optical properties, and good corrosion and chemical resistance. …”
    Get full text
    Monograph
  8. 308

    An experimental approach to determine the critical depth of cut in brittle-to-ductile phase transition during end milling of soda lime glass by Amin, A. K. M. Nurul, Begum, Mst. Nasima, Fathiah, Noor, Konneh, Mohamed, Ariff, Tasnim Firdaus

    Published 2016
    “…Due to its favorable thermal, corrosion resistance and fine chemical properties, its common applications are in the manufacture of products like mirrors, lenses, semiconductor, and optical, bio-medical and microelectronics components. Nevertheless, owing to its brittleness due to its low fracture toughness, machining of soda-lime glass is practically impossible under normal cutting conditions. …”
    Get full text
    Get full text
    Get full text
    Article
  9. 309
  10. 310

    An investigation of rhinovirus infection on cellular uptake of poly (glycerol-adipate) nanoparticles by Abo-zeid, Yasmin, Williams, Gareth, Touabi, Lila, McLean, Gary R.

    Published 2020
    “…For HeLa cells, RV-A16 and RV-A01 infection elevated NPs uptake upon increasing the incubation time, whereas at later timepoints (6 h) a reduced uptake was noted with RV-A01 infection (owing to decreased cell viability). Beas-2B cells exhibited more complex trends: decreases in NPs uptake (cf. uninfected cells) were observed at short incubation times following RV-A01 and RV-A16 infection. …”
    Get full text
    Article
  11. 311

    Annealing Treatment on Homogenous n-TiO2/ZnO Bilayer Thin Film Deposition as Window Layer for p-Cu2O-Based Heterostructure Thin Film by Mohamad Arifin, Nurliyana, Mohamad, Fariza, Hussin, Rosniza, Mohd Ismail, Anis Zafirah, Ahmad Ramli, Shazleen, Ahmad, Norazlina, Muhd Nor, Nik Hisyamudin, Sahdan, Mohd Zainizan, Mohammad Zain, Mohd Zamzuri, Masanobu Izaki, Masanobu Izaki

    Published 2023
    “…Metal oxide semiconductor material has great potential to act as window layer in p–n heterojunction solar cell thin film owing to low production cost and significant properties in photovoltaic mechanism. …”
    Get full text
    Article
  12. 312
  13. 313

    Annealing Treatment on Homogenous n-TiO2/ZnO Bilayer Thin Film Deposition as Window Layer for p-Cu2O-Based Heterostructure Thin Film by Mohamad Arifin, Nurliyana, Mohamad, Fariza, Hussin, Rosniza, Mohd Ismail, Anis Zafirah, Ahmad Ramli, Shazleen, Ahmad, Norazlina, Muhd Nor, Nik Hisyamudin, Sahdan, Mohd Zainizan, Mohammad Zain, Mohd Zamzuri, Masanobu Izaki, Masanobu Izaki

    Published 2023
    “…Metal oxide semiconductor material has great potential to act as window layer in p–n heterojunction solar cell thin film owing to low production cost and significant properties in photovoltaic mechanism. …”
    Get full text
    Article
  14. 314

    Annealing Treatment on Homogenous n-TiO2/ZnO Bilayer Thin Film Deposition as Window Layer for p-Cu2O-Based Heterostructure Thin Film by Mohamad Arifin, Nurliyana, Mohamad, Fariza, Hussin, Rosniza, Mohd Ismail, Anis Zafirah, Ahmad Ramli, Shazleen, Ahmad, Norazlina, Muhd Nor, Nik Hisyamudin, Sahdan, Mohd Zainizan, Mohammad Zain, Mohd Zamzuri, Masanobu Izaki, Masanobu Izaki

    Published 2023
    “…Metal oxide semiconductor material has great potential to act as window layer in p–n heterojunction solar cell thin film owing to low production cost and significant properties in photovoltaic mechanism. …”
    Get full text
    Article
  15. 315

    Annealing Treatment on Homogenous n-TiO2/ZnO Bilayer Thin Film Deposition as Window Layer for p-Cu2O-Based Heterostructure Thin Film by Mohamad Arifin, Nurliyana, Mohamad, Fariza, Hussin, Rosniza, Mohd Ismail, Anis Zafirah, Ahmad Ramli, Shazleen, Ahmad, Norazlina, Muhd Nor, Nik Hisyamudin, Sahdan, Mohd Zainizan, Mohammad Zain, Mohd Zamzuri, Masanobu Izaki, Masanobu Izaki

    Published 2023
    “…Metal oxide semiconductor material has great potential to act as window layer in p–n heterojunction solar cell thin film owing to low production cost and significant properties in photovoltaic mechanism. …”
    Get full text
    Article
  16. 316

    Annealing Treatment on Homogenous n-TiO2/ZnO Bilayer Thin Film Deposition as Window Layer for p-Cu2O-Based Heterostructure Thin Film by Mohamad Arifin, Nurliyana, Mohamad, Fariza, Hussin, Rosniza, Mohd Ismail, Anis Zafirah, Ahmad Ramli, Shazleen, Ahmad, Norazlina, Muhd Nor, Nik Hisyamudin, Sahdan, Mohd Zainizan, Mohammad Zain, Mohd Zamzuri, Masanobu Izaki, Masanobu Izaki

    Published 2023
    “…Metal oxide semiconductor material has great potential to act as window layer in p–n heterojunction solar cell thin film owing to low production cost and significant properties in photovoltaic mechanism. …”
    Get full text
    Article
  17. 317
  18. 318

    Aerated blast furnace slag filters for enhanced nitrogen and phosphorus removal from small wastewater treatment plants by Hamdan, Rafidah

    Published 2010
    “…Blast furnace slag (BFS) and limestone were selected for use in the ARF system owing to their high potential for P removal and their low cost. …”
    Get full text
    Thesis
  19. 319

    Remote temperature sensing with low-threshold-power using erbium-doped fiber laser by Jaharudin, Nurul Atika Nabila

    Published 2021
    “…The EDFA is used because it can operate using low pump power owing to the high gain efficiency of the doped-fibers. …”
    Get full text
    Get full text
    Get full text
    Thesis
  20. 320