-
101
Improving fluorescence imaging of biological cells on biomedical polymers
Published 2011Get full text
Article -
102
-
103
-
104
-
105
-
106
-
107
-
108
Ethics and power dynamics in playful technology for animals: using speculative design to provoke reflection
Published 2021Get full text
Conference or Workshop Item -
109
LL5 directs the translocation of Filamin A and SHIP2 to sites of phosphatidylinositol 3,4,5-triphosphate (PtdIns(3,4,5)P3) accumulation, and PtdIns(3,4,5)P3 localization is mutuall...
Published 2010“…Because F-actin initially polymerizes near the plasma membrane, it is likely that membrane-recruited Filamin A efficiently cross-links newly polymerized F-actin, leading to enhanced lamellipodium formation at the site of PtdIns(3,4,5)P3 accumulation. …”
Get full text
Article -
110
-
111
-
112
Wear characteristics of Fe-C-Si and Fe-C-Al cast irons
Published 2011“…Alumina ball of 3 mm diameter was used as pin, while the cast sample served as the disk. The tests were carried out at a normal load of 5.0 N and a sliding velocity of 250 mm/s for 30 min. …”
Get full text
Article -
113
-
114
Photonic controlled metasurface for intelligent antenna beam steering applications including 6G mobile communication systems
Published 2023“…The metasurface layer is a lattice pattern of square framed rhombus ring shaped unit-cells that are interconnected by PIN photodiodes. The metasurface layer essentially acts like a superstrate when exposed to RF/microwave radiation. …”
Get full text
Get full text
Article -
115
Empirical analysis of rough set categorical clustering techniques based on rough purity and value set
Published 2017“…The recent techniques such as Information-Theoretic Dependency Roughness (ITDR), Maximum Dependency Attribute (MDA) and Maximum Significance Attribute (MSA) outperformed their predecessor approaches like Bi-Clustering (BC), Total Roughness (TR), Min-Min Roughness (MMR), and standard-deviation roughness (SDR). …”
Get full text
Get full text
Thesis -
116
Foam replicated porous 316l stainless steel based on taguchi method for biomedical applications
Published 2018“…The optimised porosity of porous SS316L prepared by ball milling method was 85.44% and achieved using sintering time of 60 minutes, sintering temperature of 1200C, heating rate of 1C/min, SS316L composition of 60 wt% and cooling rate of 1C/min. …”
Get full text
Thesis -
117
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
118
-
119
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
120
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis