Showing 1,201 - 1,220 results of 1,229 for search '((spie OR jingge) OR ((min OR ((bina OR spinga) OR ping)) OR (pin OR (thin OR ling))))', query time: 0.09s Refine Results
  1. 1201

    Optimization of 2D sparse array antenna for FMCW radar by Mohd. Isa, Farah Nadia, Mohd. Ramli, Huda Adibah, Ismail, Ahmad Fadzil

    Published 2016
    “…It is shown that with the right choice of antenna elements thinning, the beampattern of the phased array antenna could be controlled to give the desired pattern for the users. …”
    Get full text
    Get full text
    Proceeding Paper
  2. 1202

    Ballistic impact fracture behaviour of continuous fibre reinforced al-matrix composites by Ali, Al-Hamdan, Nimir, Yassin Lutfi Mahmud, Mustafa, Ramadan J.

    Published 2010
    “…The materials response under high energy impact loads was studied using a gas gun. The projectiles were pins 1.2-1.5 mm in diameter and weighing 0.347-0.435 g. …”
    Get full text
    Article
  3. 1203
  4. 1204

    Modeling of a turning tool holder with finite elements and simulation of its free vibration frequencies by Jaafar, Israd Hakim, Shaik Dawood, Mohd. Sultan Ibrahim, Amin, A. K. M. Nurul, Shah, Qasim Hussain

    Published 2012
    “…This latter difference is unavoidable, due to the experimental test setup whereby the tool holder is clamped within the fixture with only 2 pins as opposed to the more rigid boundary condition applied to the finite element model, whereby the whole holder length within the carriage is rigidly supported at the element nodes. …”
    Get full text
    Article
  5. 1205

    Process simulation and quality evaluation of incremental sheet forming by Echrif, Salah B. M., Hrairi, Meftah

    Published 2011
    “…It allows metal forming to work in the critical ‘necking-to-tearing' zone which results in a strong thinning before failure if the process is well designed. …”
    Get full text
    Article
  6. 1206

    Isolation of nanocrystalline cellulose from leucaena leucocephala pods and its application as a fat replacer in production of low-fat mayonnaise by Aridi, Aida Safina

    Published 2022
    “…Besides that, from the rheological analysis, it can be concluded that NCC suspension behaves as a shear-thinning material. Further work was carried out to produce low-fat mayonnaise with isolated NCC as a fat replacer. …”
    Get full text
    Thesis
  7. 1207

    Gel-like properties of MCM-41 material and its transformation to MCM-50 in a caustic alkaline surround by Saputra, Hens, Othman, Raihan, Sutjipto, Agus Geter Edy, Muhida, Riza, Ani, Mohd Hanafi

    Published 2012
    “…The gel phase shows shear thinning or pseudoplastic behavior and possesses homogeneous matrix structure.…”
    Get full text
    Article
  8. 1208

    Rheological behavior and stability of cassava starch for ceramic mould binder application by Alias, Tuti Yasmin, Idris, Mohd Hasbullah, Ahmad, Zuraida, Ourdjini, Ali

    Published 2012
    “…Pseudoplastic or shear thinning behavior for both binder and slurry were observed starting at 0.13 Pa.s and 2.5 Pa.s respectively. …”
    Get full text
    Article
  9. 1209

    Aligning internal market orientation (IMO) with market orientation (MO) to impact performance in the banking sector in Ghana by Kutu-Adu, Solomon Gladstone

    Published 2017
    “…The pioneering studies of Lings and Greenley on internal market orientation (IMO) in the 2000s and that of Kohli and Jaworski experience enormous investigation empirically. …”
    Get full text
    Thesis
  10. 1210
  11. 1211
  12. 1212

    Porous ceramics with controllable properties prepared by protein foaming-consolidation method by Fadli, Ahmad, Sopyan, Iis

    Published 2011
    “…The addition of dispersant with different concentration into alumina slurries shifted the rheological properties from shear thinning behavior to a Newtonian fluid, which resulted in changes in the pore sizes of the resulting ceramics. …”
    Get full text
    Article
  13. 1213

    Prediction of sedimentation and bank erosion due to the construction of Kahang Dam by Nda, Muhammad

    Published 2020
    “…This research used the Artificial Neural Network (ANN) and ANN with Autoregressive (AR) (NNETAR) in predicting suspended sediment concentration using sediment concentration, discharge and water level as inputs. Similarly, erosion pins were installed on four transects to monitor the riverbank for thirteen months. …”
    Get full text
    Get full text
    Get full text
    Thesis
  14. 1214

    Thermal gradient pattern of shallow pitting via active thermography-water and steam by Ismon, Maznan, Chai, Ronnie, Ismail, Al Emran, Zainulabidin, Muhd Hafeez, Mat Noor, Fazimah, Abd Wahab, Hanani, Mohamad, Zaleha, Madlan, Mohd Amran, Zaman, Izzuddin

    Published 2018
    “…Pipelines are extensively used worldwide to transport water, oil and gas. Wall thinning or pits can be produced in the internal of the pipe after being used for a certain period of the time due to some factor such as erosion-corrosion and pitting corrosion. …”
    Get full text
    Article
  15. 1215
  16. 1216

    Viscosity and viscoelasticity of osteoarthritic synovial fluids in comparison to intraarticular injection of hyaluronic acid (Synvisc and Suplasyn) by Abd. Rahim, Nour El Huda, Zulkifly, Ahmad Hafiz, Mohamed, Farahidah, Ku Zaifah, Norsidah

    Published 2012
    “…RESULTS: The flow curves constructed showed that osteoarthritic SF and both IAHA exhibited non-Newtonian shear thinning (pseudoplastic) fluid behaviour. The osteoarthritic SF had the lowest viscosity compared to IAHA. …”
    Get full text
    Article
  17. 1217
  18. 1218
  19. 1219

    Convective boundary layer flow in generalized Newtonian nanofluid under various boundary conditions by Fayyadh Alshammari, Mohammed Mahdi

    Published 2021
    “…Buongiorno nanofluid model was applied to shear-thinning or pseudoplastic fluid over the pereamble surface. …”
    Get full text
    Get full text
    Get full text
    Get full text
    Thesis
  20. 1220

    Effect of dual flocculant by unmodified manihot esculenta starch and aluminium sulphate on the removal of chemical oxygen demand optimized by response surface methodology by Rahmat, S., Othman, N, Ahmad, S. N., Asharuddin, S. M.

    Published 2024
    “…Besides the performance of COD removal increased, the dosage of the chemical coagulant was reduced by up to 64% at the optimum condition of 18 mg/L alum dosage, 307 mg/L starch dosage, pH 9, and 27 mins settling time. The analysis of variance (ANOVA) indicated that the quadratic model was significantly developed with a p-value < 0.05. …”
    Get full text
    Conference or Workshop Item