-
481
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
482
ZnO / polymer junction growth for hybrid solar cell applications
Published 2011“…With the employment of zinc oxide (ZnO) and polyethylene oxide (PEO) thin films. ITO based thin films of ZnO were deposited by sputtering technique and ITO based thin films of polyethylene were deposited by solution cast technique and used as an active polymer blend. …”
Get full text
Book Chapter -
483
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
484
Fabrication and characterization of poly (ethylene oxide) for photo-electronic devices
Published 2015“…Ionic conducting polymer thin films consist of poly (ethylene oxide)-chitosan blend, ammonium iodide NH4I and iodine crystal I2 were prepared by solution cast technique at room temperature. …”
Get full text
Get full text
Proceeding Paper -
485
Enrichment of fruit wastes with white rot fungi under submerged state bioconversion
Published 2013“…On Banana and Pineapple (BPin) the protein content were recorded as18.05 and 15.75 mg/g, which was higher than Papaya and Pineapple (PinPw) and Banana and Papaya (BPw)composite. M6 has 15.4 and 9.78 mg/g on BPinPw, 13.84 and 13.59 mg/g on BPw, 20.82, and 22.97 mg/g on BPin and 18.29 and 11.59 mg/g on PinPw. …”
Get full text
Proceeding Paper -
486
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
487
Development of remote operability CNC milling
Published 2010“…Attachment consists of three main equipments; material indexing device, Sub clamp with pin and vise index…”
Get full text
Proceeding Paper -
488
The system architecture of E-braille by using the microcontroller and external controller unit
Published 2016“…This refreshable braille cell can refresh the character. The pin for each braille cell is controlled by using piezoelectric bimorph. …”
Get full text
Get full text
Article -
489
Photovoltaic activity in a ZnSe/PEO-chitosan blend electrolyte junction
Published 2007“…Abstract Thin films of ZnSe and PEO–chitosan blend polymer doped with NH4I and iodine crystals were prepared to form the two sides of a semiconductor electrolyte junction. …”
Get full text
Article -
490
Evaluation of classifiers in a pressure and latency-based typing biometric system
Published 2011“…System authentication in present time relies on validation by some sort of a password or Personal Identification Number (PIN). However, if an intruder discovers this password or PIN, the user’s account can be easily compromised. …”
Get full text
Proceeding Paper -
491
Rapid and sensitive LC method for the analysis of Gemifloxacin in Human plasma
Published 2009“…The mixture was then sonicated for 10 min followed by 20 min centrifugation at 5000 rpm (g = 3600). …”
Get full text
Article -
492
Energy absorption performance of braided basalt reinforced composite tubes under axial loads
Published 2018“…The thin-walled composite tube is recognised as a potential replacement for thin-walled metal tubes in light-weight structures. …”
Get full text
Thesis -
493
Enlighten architecture students on environmental design through computer simulation
Published 2013Get full text
Get full text
Proceeding Paper -
494
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
495
-
496
Fabrication of frequency selective structure and evaluation of microwave transmission on energy saving glass
Published 2015“…This energy saving property is achieved by applying a very thin tin oxide (SnO2) coating on one side of the glass. …”
Get full text
Get full text
Get full text
Thesis -
497
In-situ melting assessment of AZ91D magnesium alloy investment casting
Published 2024Get full text
Thesis -
498
Electrodeposition of nanostructure materials
Published 2015“…We are conducting a multi-disciplinary research work that involves development of nanostructured thin films of semiconductors for different applications. …”
Get full text
Book Chapter -
499
Finite element modelling of fixed-fixed end plate attached with vibration absorber
Published 2016“…The present paper investigated the effect of the lightweight dynamic vibration absorber (LDVA) to reduce vibration of thin walled structure. The free and forced vibration response of a rectangular thin plate were performed using finite element method. …”
Get full text
Article -
500
Nanoparticle-coated Vivaldi antenna array for gain enhancement
Published 2023“…Furthermore, it is shown for the first time that by depositing a thin film of Graphene/copper nanoparticles onto the CSRR, the array’s gain is increased to 10 dBi at 180 degrees with sidelobe reduction of better than 15 dB.…”
Get full text
Get full text
Article