-
141
Biomechanical evaluation and new improvement on ankle external fixator
Published 2023Get full text
Thesis -
142
Bio-fuel-contaminated lubricant and hardening effects on the friction and wear of AISI 1045 steel
Published 1998“…A study has been made on the wear and fiction of hardened AISI 1045 steel using a pi-pin-ondisc type of fiction and wear apparatus. During the investigation the linear pin wear, coe@cient of friction and rise in pin specimen temperature were monitored and wear and fiction curues 'plotted. …”
Get full text
Article -
143
Voicing contrast in word-final stops: A preliminary study of Malay English
Published 2000Get full text
Article -
144
Development of switchable planar reflectors for beam shaping realization
Published 2016“…The objective of this work was to investigate the feasibility of using strategic slot embedded patch element configurations for an efficient reconfigurable reflectarray antenna design. PIN diodes were incorporated with single and multiple slot embedded patch element configurations for the design of beam switchable planar reflectors. …”
Get full text
Get full text
Get full text
Thesis -
145
The system architecture of E-braille by using the microcontroller and external controller unit
Published 2016“…This refreshable braille cell can refresh the character. The pin for each braille cell is controlled by using piezoelectric bimorph. …”
Get full text
Get full text
Article -
146
Enrichment of fruit wastes with white rot fungi under submerged state bioconversion
Published 2013“…On Banana and Pineapple (BPin) the protein content were recorded as18.05 and 15.75 mg/g, which was higher than Papaya and Pineapple (PinPw) and Banana and Papaya (BPw)composite. M6 has 15.4 and 9.78 mg/g on BPinPw, 13.84 and 13.59 mg/g on BPw, 20.82, and 22.97 mg/g on BPin and 18.29 and 11.59 mg/g on PinPw. …”
Get full text
Proceeding Paper -
147
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
148
Development of remote operability CNC milling
Published 2010“…Attachment consists of three main equipments; material indexing device, Sub clamp with pin and vise index…”
Get full text
Proceeding Paper -
149
Evaluation of classifiers in a pressure and latency-based typing biometric system
Published 2011“…System authentication in present time relies on validation by some sort of a password or Personal Identification Number (PIN). However, if an intruder discovers this password or PIN, the user’s account can be easily compromised. …”
Get full text
Proceeding Paper -
150
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
151
Multi-Mode Yagi Uda Patch Array Antenna With Non-Linear Inter-Parasitic Element Spacing
Published 2023“…Applying the inter-parasitic element spacing’s optimization and minimizing the switching circuitry using four RF PIN diodes on the parasitic elements have contributed to the gain achievement of more than 7 dBi.…”
Get full text
Article -
152
-
153
-
154
Wear characteristics of Fe-C-Si and Fe-C-Al cast irons
Published 2011“…In the present study, wear behavior of the Fe-C-Si and Fe-C-Al cast irons were investigated using a pin-on-disk type apparatus at room temperature. …”
Get full text
Article -
155
-
156
Low-loss paper-substrate triple-band-frequency reconfigurable microstrip antenna for sub-7 GHz applications
Published 2023“…In this paper, a low-cost resin-coated commercial-photo-paper substrate is used to design a printed reconfigurable multiband antenna. The two PIN diodes are used mainly to redistribute the surface current that provides reconfigurable properties to the proposed antenna. …”
Get full text
Get full text
Article -
157
The tribological behaviour of Fe-C-Al cast iron – effect of temperature
Published 2013“…Purpose - The aim of this paper is to study the tribological behaviour of Fe-C-Al cast iron at different temperatures using universal pin-on-disk machine. Design/methodology/approach - The cold set resin bonded sand mould casting process was employed to develop Fe-C-Al cast iron and Fe-C-Si cast iron. …”
Get full text
Article -
158
Innovative UWB phase shifters using groove gap-waveguide technology inspired by metasurfaces for beamforming networks operating at 100 GHz
Published 2025“…The metasurface features a "bed-of-nails" structure, where metal pins are connected to a bottom layer and spaced <λ/4 from a top plate. …”
Get full text
Conference or Workshop Item -
159
A study of touching behavior for authentication in touch screen smart devices
Published 2016“…Due to increasing demand for safer access in touch screen mobile phones, old strategies like pins, tokens, or passwords have failed to stay abreast of the challenges. …”
Get full text
Get full text
Proceeding Paper -
160
Metamaterial based ultra-wideband antennas for portable wireless applications
Published 2017“…Various approaches have been reported to reduce the physical size of RF antennas including using high permittivity substrates, shorting pins, reactive components, and more recently, metamaterials (MTM) based on composite right-/left-handed transmission-lines (CRLH-TLs). …”
Get full text
Book Section