-
21
The XR Beam - a trussed hardwood beam for value-added use of roundwood thinnings in the South-East of England
Published 2020Get full text
Conference or Workshop Item -
22
Fabrication and optimization of N-Cu2O thin film using electrodeposition method for homojunction solar cell
Published 2018“…Ultra violet-visible (UV-Vis) spectrophotometer was used to study the optical absorption of Cu2O and to determine the band gap of the deposited thin film with further calculation including the thickness values of the thin film measured by surface profiler. …”
Get full text
Get full text
Get full text
Thesis -
23
-
24
Optimization of titanium dioxide (TiO2) thin film using dip coating technique for oxygen gas sensor
Published 2017“…Titanium dioxide (TiO2) thin film gas sensors have been widely used and investigated in the detection of target gases. …”
Get full text
Get full text
Get full text
Thesis -
25
Effect of calcination temperature on bilayer TiO2/ZnO and ZnO/TiO2 thin films
Published 2018“…Thin film is a thin material that resulting from the condensation of species through the deposition of atoms on substrate. …”
Get full text
Get full text
Get full text
Thesis -
26
-
27
Aluminium nitride (AlN) as buffer layer for deposition of gallium nitride (GaN) thin films on silicon substrates using magnetron sputtering technique
Published 2021“…The effect of thick and thin buffer layer to the GaN will be studied to see which will provide the lowest resistivity and high n-type carrier concentration for the GaN thin films. …”
Get full text
Get full text
Get full text
Thesis -
28
-
29
-
30
-
31
Solving security staff scheduling by using genetic algorithm
Published 2021Get full text
Get full text
Get full text
Thesis -
32
-
33
-
34
Development of switchable planar reflectors for beam shaping realization
Published 2016“…Higher tunable loss factor of 1.91dB was demonstrated by liquid crystal based design as compared to tunable loss factor of 1.43dB shown by PIN diode based design. The investigations were further extended by carrying out equivalent circuit analysis of PIN diode based and liquid crystal based designs for detailed characterization of reconfigurable planar reflector designs. …”
Get full text
Get full text
Get full text
Thesis -
35
Characterization of cyclic plasticity type wear mechanism for titanium alloy, TI-6AL-4V on reciprocating sliding wear test
Published 2020“…Meanwhile for the contact pin, two different diameter cylinders are used i.e Ø6.5 mm and Ø12 mm. …”
Get full text
Get full text
Get full text
Thesis -
36
Electrical breakdown and structural characterization in synthetic resins using optical techniques
Published 1992“…The early tree growth is shown to be driven by the high electrical field near the pin tip, which is itself dependent on the pin-plane electrode separation as well as the applied voltage. …”
Get full text
Thesis -
37
An investigation of defect formation and growth in epoxy resin using light scattering methods
Published 1989“…The later has been attributed to failure occurring at the pin tip epoxy interface causing relaxation in the scattering volume. …”
Get full text
Thesis -
38
Energy absorption performance of braided basalt reinforced composite tubes under axial loads
Published 2018“…The thin-walled composite tube is recognised as a potential replacement for thin-walled metal tubes in light-weight structures. …”
Get full text
Thesis -
39
Fabrication of frequency selective structure and evaluation of microwave transmission on energy saving glass
Published 2015“…This energy saving property is achieved by applying a very thin tin oxide (SnO2) coating on one side of the glass. …”
Get full text
Get full text
Get full text
Thesis -
40
Biomechanical evaluation and new improvement on ankle external fixator
Published 2023Get full text
Thesis