-
441
-
442
-
443
Graphene antenna design and characterisation for fifth generation applications
Published 2024Get full text
Thesis -
444
Optimization of EDM parameters for micro/meso fabrication
Published 2006“…The surface of the microchannels was inspected by using scanning electron microscope (SEM). The surface finish and accuracy were measured by Mitutoyo surface roughness tester and profile projector PJ-311 respectively. …”
Get full text
Proceeding Paper -
445
Predicting group of metabolites available in partially purified tomato leaves extract showing anticancer activity by high performance liquid chromatography (HPLC) and Fourier tr...
Published 2011“…The collection of FTIR spectra was carried out at 16 scans with resolution of 4 cm -1 using strong apodization in the frequency regions of 4,000 to 650 cm-1.The results support the premise that HPLC and FTIR spectroscopy are efficient and accurate methods for determining major and minor components presents in the extract.…”
Get full text
Article -
446
Computational investigation on CSF flow analysis in the third ventricle and aqueduct of sylvius
Published 2011“…In this study, a three dimensional (3D) model of the third ventricle and aqueduct of Sylvius derived from MRI scans was constructed by using Computational Fluid Dynamics (CFD) modeling. …”
Get full text
Article -
447
Waste palm shell converted to high efficient activated Carbon by chemical activation method and its adsorption capacity tested by water filtration
Published 2012“…Obtained BET surface area is 1058 m2g-1 and the average pore diameter was found 20.64 nm. Scanning electron microscopy (SEM) also confirmed the pore size distribution on the activated carbon. …”
Get full text
Proceeding Paper -
448
Influence of nanosilica/polyurethane composite coating on IR effectiveness and visible light transmission properties of polyethylene
Published 2010“…The uniformity of silica dispersion was probed using scanning electron microscopy (SEM). With the introduction of nanosilica to polyurethane binder, the visible light transmittance and ultra-violet (UV) radiation of nanosilica-polyurethane system reduced with increasing nanosilica content and coating layer thickness. …”
Get full text
Article -
449
The effect of water and citric acid on sago starch bio-plastics
Published 2011“…The samples were also tested by scanning electron microscopy (SEM). It is obvious that the addition of the CA at 30 wt/wt% improve the mechanical property of BPS to more than 40% compare to the addition of water.…”
Get full text
Proceeding Paper -
450
Enzymatic hydrolysis of granular native and mildly heat-treated tapioca and sweet potato starches at sub-gelatinization temperature
Published 2009“…The dextrose equivalent (DE) value of heat-treated starch increased significantly compared to native starch, i.e., 36–50% and 27–34% for tapioca and sweet potato starch, respectively. Scanning electron microscopy examination showed that enzymatic erosion occurred mainly at the surface of starch granules. …”
Get full text
Article -
451
Waste palm shell converted to high efficient activated carbon by chemical activation method and its adsorption capacity tested by water filtration
Published 2012“…Obtained BET surface area is 1058 m2g-1 and the average pore diameter was found 20.64 nm. Scanning electron microscopy (SEM) also confirmed the pore size distribution on the activated carbon. …”
Get full text
Article -
452
Developing a prototype micro hot embossing setup
Published 2005“…The fabricated microcomponents were inspected by scanning electron microscope where some defects were identified as the forming process was not optimized yet. …”
Get full text
Proceeding Paper -
453
Development of kenaf-glass reinforced unsaturated polyester hybrid composite for structural applications
Published 2014“…The highest flexural, tensile and impact strength were obtained from treated kenaf with 15/15 v/v KG fibres reinforced UPE hybrid composite in this investigation. Scanning electron microscopy fractography showed fibre cracking, debonding and fibre pulled-out as the main fracture mode of composites and kenaf treated 15/15 v/v KG reinforced hybrid composite exhibited better interfacial bonding between the matrix and reinforcement compared to other combinations.…”
Get full text
Get full text
Article -
454
Synthesis of carbon nanofibers on impregnated powdered activated carbon as cheap substrate
Published 2016“…New functional groups were also appeared compared to those in the PAC. Field Emission Scanning Microscopy (FESEM), Transmission Electron Microscopy (TEM), Fourier Transform Infrared (FTIR), BET surface area analysis and Energy Dispersive X-ray analyzer (EDX) were used for the characterization of the new carbon nano product, which was produced through a clean novel process.…”
Get full text
Get full text
Get full text
Article -
455
The glass transition temperature of iron and titanium containing phosphate based glasses
Published 2015“…In this study various compositions in the phosphate based glass (PBG) system of (50-x)P2O5-40Ca- (5+x)Na-5TiO2 and (50-x)P2O5-40Ca-(5+x)Na-5Fe2O3, where x= 5 and 10 were investigated for glass transition temperature (Tg) via thermo mechanical analyser (TMA) and differential scanning calorimetry (DSC). The amorphous nature of the glasses was confirmed via XRD. …”
Get full text
Article -
456
Effect of surface roughness on adhesion strength in ultrasonic soldering of glass
Published 2015“…Study on bonding mechanism was conducted by using scanning electron microscope (SEM) and energy dispersive X-ray spectroscopy (EDX). …”
Get full text
Article -
457
Fracture surface behaviour of Al-Mg-SiCp composite materials
Published 2016“…Fractographic observations were evaluated with the scanning electron microscopy (SEM) on the fracture surface. …”
Get full text
Get full text
Proceeding Paper -
458
Surface modification of HSLA steel and its fracture behavior
Published 2016“…The fractography analysis results by scanning electron microscopy (SEM) were also presented in this paper.…”
Get full text
Proceeding Paper -
459
Probabilistic model of laser range finder for three dimensional grid cell in close range environment
Published 2016“…The laser was placed in a controlled environment consisting of walls at a close range and 1000 iteration of scans was collected. The assumption of normal density of the metrical data collapses when the beam traverses across sharp edges in this environment. …”
Get full text
Get full text
Article -
460
Acid corrosion inhibition of copper by mangrove tannin
Published 2011“…Design/methodology/approach – The mangrove tannin was extracted from the mangrove bark and its anticorrosion potential was studied by weight loss, electrochemical and scanning electron microscopy (SEM) analysis. Findings – It has been found that the mangrove tannin effectively inhibits the corrosion on copper metal in hydrochloric acid solution. …”
Get full text
Article