-
281
-
282
-
283
-
284
Annealing Treatment on Homogenous n-TiO2/ZnO Bilayer Thin Film Deposition as Window Layer for p-Cu2O-Based Heterostructure Thin Film
Published 2023“…In this work, n-TiO2/ZnO bilayer thin film was effectively constructed by means of sol-gel spin coating technique in an effort to diminish the electron-hole recombination rate from single-layered thin film. …”
Get full text
Article -
285
Annealing Treatment on Homogenous n-TiO2/ZnO Bilayer Thin Film Deposition as Window Layer for p-Cu2O-Based Heterostructure Thin Film
Published 2023“…In this work, n-TiO2/ZnO bilayer thin film was effectively constructed by means of sol-gel spin coating technique in an effort to diminish the electron-hole recombination rate from single-layered thin film. …”
Get full text
Article -
286
Annealing Treatment on Homogenous n-TiO2/ZnO Bilayer Thin Film Deposition as Window Layer for p-Cu2O-Based Heterostructure Thin Film
Published 2023“…In this work, n-TiO2/ZnO bilayer thin film was effectively constructed by means of sol-gel spin coating technique in an effort to diminish the electron-hole recombination rate from single-layered thin film. …”
Get full text
Article -
287
Annealing Treatment on Homogenous n-TiO2/ZnO Bilayer Thin Film Deposition as Window Layer for p-Cu2O-Based Heterostructure Thin Film
Published 2023“…In this work, n-TiO2/ZnO bilayer thin film was effectively constructed by means of sol-gel spin coating technique in an effort to diminish the electron-hole recombination rate from single-layered thin film. …”
Get full text
Article -
288
Annealing Treatment on Homogenous n-TiO2/ZnO Bilayer Thin Film Deposition as Window Layer for p-Cu2O-Based Heterostructure Thin Film
Published 2023“…In this work, n-TiO2/ZnO bilayer thin film was effectively constructed by means of sol-gel spin coating technique in an effort to diminish the electron-hole recombination rate from single-layered thin film. …”
Get full text
Article -
289
Effect of calcination temperature on bilayer TiO2/ZnO and ZnO/TiO2 thin films
Published 2018“…Thin films are produced on glass substrate via spin coating method at speed of 3000 rpm and were calcined at different calcination temperatures that are 400 oC, 500 oC, and 600 oC. …”
Get full text
Get full text
Get full text
Thesis -
290
Low-temperature growth of zinc oxide structures on flexible conductive substrate: effect of NaOH and C7H8O9 presence in solgel
Published 2021“…The precursor solutions were spin-coated on the ITO/PET substrate and were dried at room temperature and pre-heated oven at 150°C for 3 minutes. …”
Get full text
Get full text
Get full text
Thesis -
291
Wideband and multiband antennas for multi-configuration mode applications
Published 2023Get full text
Thesis -
292
-
293
-
294
-
295
Machinability improvement in end milling of Titanium Alloy Ti-6Al-4V through preheating
Published 2011“…Ozler et al [7] used gas flame heating to improve the machinability of austenitic manganese steel. Wang et al [8] performed LAM using YAG continuous solid laser on Al2O3 particle reinforced aluminum matrix composite (Al2O3p/Al). …”
Get full text
Book Chapter -
296
-
297
Novel opto-electronic and plastic fibre sensors
Published 1998“…The middle POF is coupled to a red LED and emits light onto a flat target with the two outer fibres receiving the reflected light from the target and guiding it to two silicon PIN photodiodes. Theoretical investigations on the behaviour of the sensor are presented for ranges between 0 mm and 100 mm, and for targets with different reflectivities. …”
Get full text
Thesis -
298
-
299
-
300