Stability analysis of unsteady flow and heat transfer of rear stagnation point in hybrid nanofluids with thermal radiation and magnetic impact by Nurul Amira, Zainal, Iskandar, Waini, Najiyah Safwa, Khashi’ie, Khairum, Hamzah, Sayed Kushairi, Sayed Nordin, Abdul Rahman, Mohd Kasim, Roslinda, Mohd Nazar, Pop, Ioan Mihai

“…The influence of several parameters is taken into consideration including magnetic parameter, radiation parameter, and heat transfer. The well-known heat transfer fluid that is Al2O3-Cu/H2O hybrid nanofluid past a rear stagnation point is implied. …”
Get full text

Investigation of moisture content and higher heating value in refuse-derived fuel from agricultural residues using statistical modelling by Nuranis Yasira, Abd Halim, Noor Intan Shafinas, Muhammad

“…One of the alternative fuels considered is Refuse-derived fuel (RDF) from biomass, which has a Higher Heating Value (HHV) comparable to coal. This study aims to investigate the relationship between the moisture content and the HHV value. …”
Get full text

Performance evaluation of low-pressure turbine, turbo-compounding and air-Brayton cycle as engine waste heat recovery method by Teo, Aaron Edward Sheng Jye, Chiong, Meng Soon, Yang, Mingyang, Romagnoli, Alessandro, Martinez-Botas, Ricardo F., Rajoo, Srithar

“…This paper presents an equivalent comparison of waste heat recovery method on an internal combustion engine using low-pressure turbine (LPT), turbo compound (TC) & air-Brayton cycle (ABC). …”
Get full text

Novel heat treatment methodology for residual stress relieve of AlSi10Mg without compromise of mechanical strength by Lim, Chong Heng

“…The current conventional method of relieving the residual stresses of LBPB manufactured AlSi10Mg involves heat treatment to 300ºC. However, AlSi10Mg manufactured by the LBPB process is much more sensitive to heat treatment as compared to conventional cast AlSi10Mg, resulting in a drastic reduction in mechanical strength after heat treatment. …”
Get full text

Experimental & simulation study of 16kWp photovoltaic (PV) system performance & the investigation of PV heat island effect by Devihosur, Shiddalingeshwar Channabasappa

“…This dissertation documents the experimental and simulation investigation of a 16kWp solar photovoltaics (PV) system’s (located in SIT@Dover) performance along with the investigation of the urban heat island (UHI) effect resulting from the PV system. …”
Get full text

Post-processing of cold sprayed CoNiCrAlY coatings on Inconel 718 by rapid induction heating by Yang, Yongjing, Aprilia, Aprilia, Wu, Kaiqiang, Tan, Sung Chyn, Zhou, Wei

“…Then the coatings were heat treated at 800◦ C, 900◦ C, 1000◦ C and 1100◦ C by rapid induction heating. …”
Get full text

Experimental investigation on the dynamics of an Organic Rankine Cycle evaporator with large-mass fins for the purpose of reducing heat input fluctuations by Jiménez-Arreola, Manuel, Wieland, Christoph, Romagnoli, Alessandro

Subjects: Get full text

Developing an experimental test rig to analogically test the flow and heat transfer through a severely constricted carotid artery by Ho, Darren Jia Lun

“…This report has discussed the experimental investigations performed pertaining to heat transfer from flow models, with aims to characterise flow properties in an analogical vessel. …”
Get full text

Nanostructured tungsten carbide/carbon composites synthesized by a microwave heating method as supports of platinum catalysts for methanol oxidation by Lu, Jin Lin, Li, Zi Hui, Jiang, San Ping, Shen, Pei Kang, Li, Lin

“…In this work, a series of nanostructured tungsten carbide/carbon (WC/Cx) composites are in situ synthesized using a microwave heating method. The composites are used as platinum (Pt) catalyst supports for methanol oxidation in acid media. …”
Get full text
Get full text

Changes in stability, phytonutrients, 3-chloropropanol esters and glycidyl esters of peanut oil-based diacylglycerols during heat treatment by Lv, Yongsi, Peng, Xianwu, Lee, Yee-Ying, Xie, Xiaodong, Tan, Chin Ping, Wang, Ying, Wang, Yong, Zhang, Zhen

“…This study aimed to evaluate static heating and stir-frying properties of peanut oil (PO) and PO based 58% and 82% DAG oils (PDAG-58 and PDAG-82). …”
Get full text

Hybrid nanofluid radiative flow across a permeable convective moving surface with heat generation: numerical and statistical approach by Wahid, Nur Syahirah, Mustafa, Mohd Shafie, Md Arifin, Norihan, Khashi’ie, Najiyah Safwa, Pop, Ioan

“…Dual solutions are identified, and their stability is confirmed through rigorous stability analysis. To optimize heat transfer enhancement, the study employs response surface methodology (RSM) to refine key parameters—specifically thermal radiation, heat generation, and the Biot number—with the goal of achieving maximum heat transfer efficiency. …”

Understanding thermal unsteadiness in engine representative flows and improved methodologies for derived heat transfer calculations using thin-film gauges by Singh, D, Beard, PF, Cardwell, D, Chana, KS

“…The Oxford Turbine Research Facility (OTRF) is a high-speed rotating transient test facility, which allows unsteady aerodynamic and heat transfer measurements at engine representative conditions. …”

Numerical study of heat transffer for laminar flow in microtube with helically spiral rib/groove using AL203/water nanofluid / by Thillai Mugilan Thallai Muthu, 1988- 554096, Nor Azwadi Che Sidik, 1977-, 612329, Fakulti Kejuruteraan Mekanikal 8081

Heat transfer and energy performance analysis of photovoltaic thermal system using functionalized carbon nanotubes enhanced phase change material by Rajamony, Reji Kumar, Pandey, A. K., Mahendran, Samykano, Johnny Koh, Siaw Paw, Kareri, Tareq, Laghari, Imtiaz Ali, Tyagi, V. V.

“…At a flow rate of 0.4litter per minute, a significant heat gain was achieved with an impressive energy-saving efficiency of 75.67 %. …”
Get full text
Get full text

Effects of heat treatment parameters on the microstructure and mechanical properties of laser power bed fusion (LPBF) 316L stainless steel by Sun, Yuheng

“…This study investigates the recrystallization mechanisms during heat treatment of LPBF 316L to achieve comparable mechanical properties and microstructures to conventionally manufactured (CM) 316L. …”
Get full text

The significant effect of hydromagnetic on carbon nanotubes based nanofluids flow and heat transfer past a porous stretching/shrinking sheet by Abdul Samat, Nazrul Azlan, Bachok, Norfifah, Md Arifin, Norihan

“…The 2D steady flow model of carbon nanotubes-based nanofluids and heat transfer past a porous stretchable or shrinkable sheet is studied analytically and numerically. …”
Get full text

The onset of convection driven by buoyancy effects caused by various modes of transient heat conduction: Part I. Transient Rayleigh numbers by Tan, Ka Kheng, Thorpe, Rex B

“…The onset of convection induced by transient heat conduction in deep fluid is examined for two boundary conditions, namely: fixed surface temperature (FST) and linear rate of change of surface temperature with respect to time (LTR). …”
Get full text

Al2O3-Cu hybrid nanofluid flow and heat transfer characteristics in the duct with various triangular rib configurations by Togun, Hussein, Homod, Raad Z., Sultan Aljibori, Hakim S., Abed, Azher M., Alias, Hajar, Hussein, Ahmed Kadhim, Biswal, Uddhaba, Al-Thamir, Mohaimen, Mahdi, Jasim M., Mohammed, Hayder I., Ahmadi, Goodarz

“…This study examines the turbulent heat transfer characteristics of Al2O3–Cu hybrid nanofluids in circular ducts with triangular rib configurations. …”

A general and facile method for preparation of large-scale reduced graphene oxide films with controlled structures by Bi, Hengchang, Wan, Shu, Cao, Xiehong, Wu, Xing, Zhou, Yilong, Yin, Kuibo, Su, Shi, Ma, Qinglang, Sindoro, Melinda, Zhu, Jingfang, Zhang, Zhuoran, Zhang, Hua, Sun, Litao

Subjects: Get full text

Simulation of Organic Rankine Cycle - quasi-steady state vs dynamic approach for optimal economic performance by Pili, Roberto, Romagnoli, Alessandro, Jiménez-Arreola, Manuel, Spliethoff, Hartmut, Wieland, Christoph

Subjects: Get full text