Preliminary Study Of The Utilization Of Ash Waste by Perpustakaan UGM, i-lib

“…The investigated process conditions are the mixture composition of required raw materials and the sintering conditions (e.g. temperature, duration, etc.). …”

Pengaruh Kandungan Serbuk Alumina Terhadap Kekerasan Dan Kekuatan Bending Komposit Paduan Al-Si/Alumina by Perpustakaan UGM, i-lib

“…The green bodies were then pressureless sintered in argon atmosphere for 2 hours. The results show that the relative density decreases with increasing alumina contents. …”

AN EFFICIENT AND REPRODUCIBLE APPROACH FOR ATTAINING SUPERCONDUCTIVITY AT 128-K IN TL2BA2CA2CU3O10-DELTA by Liu, R, Tallon, J, Edwards, P

“…This procedure involves synthesizing a material with nominal stoichiometry Tl1.6Ba2Ca2.4Cu3O10-δ, which was sintered at 910°C for 3 h, annealed at 750°C (10 days) in an evacuated quartz tube, and finally annealed at 600°C (2 h) in a 0.2% oxygen/nitrogen gas mixture. …”

Preliminary morphological studies on the effect of substitution in yttrium iron garnet system by See, Alex, Yahya, Noorhana, Hashim, Mansor

“…The Y3.0-XLaXFe5O12 series were sintered at 1300°c for 10 hours. XRD studies confirmed the garnet phase of all the samples. …”
Get full text

Development of MgZn-Based ferrite materials for deflection yokes by Thor, Soo Fung

“…Green compacts with a sintering temperature of 1150°C and only air atmosphere were needed to achieve the magnetic and electrical properties close to those of SAMHWA's YL-5 material. …”
Get full text

Fabrication and characterization of some NiZn-based ferrite multilayer inductors (MLIS) by Liew, Lucia Woan Shyan

“…Bulk and multilayered components of the same dimension were made to undergo parallel conventional sintering. The experimental work resulted in the complete construction of a tape-casting setup. …”
Get full text

Assessment of the Behaviour of Soil Structure in Double-Porosity Kaolin Media Using Light Transmission Visualization (LTV) Method by Alazaiza, M. Y. D., Ngien, S. K., Bob, Mustafa M., Samira, A. Kamaruddin, Wan Faizal, Wan Ishak

“…Aggregated kaolin and sintered clayey spheres mixture were used as the media for the first and second test, respectively. …”
Get full text

An assessment of the longevity of samarium cobalt trioxide perovskite catalyst during the conversion of greenhouse gases into syngas by Osazuwa, Osarieme U., Khan, Maksudur R., Lam, Su Shiung, Assabumrungrat, Suttichai, Cheng, C. K.

“…However, rapid catalyst deactivation and sintering due to carbon deposition often accompany the CO2 reforming of CH4 reaction. …”
Get full text

The development of Zirconia and Copper toughened Alumina ceramic insert by Nur Amalina, Sabuan, Nurfatini, Zolkafli, Mebrahitom, A., Azmir, Azhari, Othman, Mamat

“…A uniaxial pre-forming process of the mix powder was done prior to densification by sintering at 1000 and 1300°C. The effect of the composition of the reinforcement on the hardness, density, shrinkage and microstructure of the inserts was investigated. …”
Get full text

Review of Aluminum Chip Machining Using Direct Recycling Process by A. R., Yusoff, Mohamad Syahmi, Shahrom

“…Then almost researchers applied hot extrusion it is because to cover sintering process.…”
Get full text

Nickel cobalt oxide nanowire-reduced graphite oxide composite material and its application for high performance supercapacitor electrode material by Wang, Xu, Yan, Chaoyi, Sumboja, Afriyanti, Lee, Pooi See

“…In this paper, we report a facile synthesis method of mesoporous nickel cobalt oxide (NiCo2O4) nanowire-reduced graphite oxide (rGO) composite material by urea induced hydrolysis reaction, followed by sintering at 300 °C. P123 was used to stabilize the GO during synthesis, which resulted in a uniform coating of NiCo2O4 nanowire on rGO sheet. …”
Get full text
Get full text

Preparation and properties of mesoporous carbon composite as negative electrode materials by Zhao, Zhengping, Shen, Sitao, Chen, Feng, Zhong, Mingqiang, Chew, Jia Wei

“…The spacing of the molybdenum disulfide coating on the surface was 0.52 nm. After sintering, the diameter of microspheres is about 300 nm and the surface aperture of MoS2@C microspheres is about 300 nm. …”
Get full text

Aqueous tape casting technique for the fabrication of Sc0.1Ce0·01Zr0·89O2+Δ ceramic for electrolyte-supported solid oxide fuel cell by Zhou, Juan, Zhang, Lan, Liu, Chao, Pu, Jiangge, Liu, Qinglin, Zhang, Caizhi, Chan, Siew Hwa

“…In this work, a large-area electrolyte-supported solid oxide fuel cell was fabricated by this technique together with sintering. A 10 cm × 10 cm and 0.17 mm thick supported Sc0.1Ce0·01Zr0·89O2+△ (SSZ) electrolyte was obtained with good flatness, low ohmic resistance and high open-circuit voltage.…”
Get full text

Analytical solution of temperature distribution in a nonuniform medium due to a moving laser beam and a double beam scanning strategy in the selective laser melting process by Loh, Loong-Ee, Song, Jie, Guo, Fenglin, Bi, Guijun

“…In this paper, a double beam scanning strategy is investigated in which the first laser beam preheats the powder just below the sintering point while the second laser beam completely melts the powder. …”
Get full text
Get full text

Synthesis and visible light photocatalytic properties of SrTi(1−x)FexO(3−δ) powder for indoor decontamination by Huang, H., Ghaffari, Mohammad, Tan, Puay-Yok, Tan, Ooi Kiang

“…The obtained results showed that the SrFeO3 (STF1) sample has the best photocatalytic activity in the SrTi(1 − x)FexO(3 − δ) (0 ≤ x ≤ 1) series and with reduced temperature of sintering the properties that improved due to smaller crystallite size and particle size.…”
Get full text
Get full text

Fabrication and properties of highly transparent Er:YAG ceramics by Qin, Xianpeng, Yang, Hao, Zhou, Guohong, Luo, Dewei, Yang, Yan, Zhang, Jian, Wang, Shiwei, Ma, Jan, Tang, Dingyuan

“…Highly transparent Er:YAG ceramics with different Er doping concentrations were fabricated by a reactive sintering method under vacuum. The optical properties and the microstructures of the Er:YAG ceramics were investigated. …”
Get full text
Get full text

Diode pumped highly efficient Yb:Lu3Al5O12 ceramic laser by Zhang, J., Yang, H., Xu, C. W., Luo, D. W., Tan, W. D., Qin, Xianpeng, Tang, Dingyuan

“…Using the solid state reactive vacuum sintering technique we have successfully fabricated high optical quality Yb:LuAG ceramics. …”
Get full text
Get full text

Application of low cost polyurethane (PU) foam for fabricating porous tri-calcium phosphate (TCP) by Abdul Rahman, Fariza, Ahmad, Zuraida, Iis, Sopyan

“…Subsequently,rectangular shaped PU foam was immersed in the slurry and dried for three days. Samples were then sintered at 1100°C to obtain porous tri-calcium phosphate. …”
Get full text

Dielectric and conduction processes and behaviours in Ni0.3Zn0.7Fe2O4 by Mat, Mohd Noor, Mohamed Kamari, Halimah, Wan Yusoff, Wan Mohamad Daud, Hashim, Mansor, Nizam, H., Zainuddin, Y., Aiman, T. I. T. M.

“…The sample was prepared by mixing Zinc Oxide, Nickel Oxide and Iron Oxide and sintered at 1573 K for 10 hours long. Dielectric properties were studied using Novo Control Dielectric Spectrometer. …”
Get full text

A preliminary study on FDM prototype surface roughness by Khan, Shah Fenner, Salleh, Ahmad Faizal, Sharif, Safian, Mohamad, Zulkepli, A. Rashid, Zulkifli, Murad, Muhamad Nasir

“…Processes such as stereolithography (SLA), selective laser sintering (SLS), fused deposition modeling (FDM), layered object modeling (LOM) and 3D Printing (3DP) are part of this technology. …”
Get full text