Simulation of plastic injection moulding of a car door - handle trim using moldex and design of experiment (DOE) [electronic resource] /

Схожие документы

• Simulation of plastic injection moulding of a car door-handle trim using moldex and design of experiment (DOE) /
  по: 389833 Ngu, Ying Kui, и др.
  Опубликовано: (2008)
• Simulation on sink mark defect of plastic injection moulding of Proton Iswara outer door handle trim using moldex software and D.O.E. classical method /
  по: Tan, Sze Ling, и др.
  Опубликовано: (2008)
• Simulation on sink mark defect of plastic injection moulding of Proton Iswara outer door handle trim using moldex software and D.O.E. classical method [electronic resource] /
  по: 308603 Tan, Sze Ling
  Опубликовано: (2008)
• Simulation of plastic injection moulding of a computer part using moldex software and design of experiment (DOE) /
  по: Remnesh Kumar Rajasekaran, 1986-, и др.
  Опубликовано: (2010)
• Simulation of plastic injection moulding fishing component using moldex software and D.O.E method /
  по: Mohd. Mulyadi Umar, 1986-, и др.
  Опубликовано: (2009)