Partition layout inside a muffler integrated with a thermoelectric generator: Multi-physics analysis and optimal design

Partition layout inside a muffler integrated with a thermoelectric generator: Multi-physics analysis and optimal design

A multi-physics-analysis-based topology optimization (TO) method is proposed to optimally design the internal partition layout of a muffler integrated with a thermoelectric generator (TEG). The basic equations governing the acoustical behavior, heat transfer, and fluid flow in the muffler are introd...

Полное описание

Библиографические подробности
Главные авторы:	Kee Seung Oh, Jin Woo Lee
Формат:	Статья
Язык:	English
Опубликовано:	SAGE Publishing 2022-12-01
Серии:	Journal of Low Frequency Noise, Vibration and Active Control
Online-ссылка:	https://doi.org/10.1177/14613484221113339

Схожие документы

Research on characteristics of thermoelectric generator with integrated muffler and catalytic converter
по: Xun Liu, и др.
Опубликовано: (2022-04-01)

Acoustics of ducts and mufflers /
по: 206483 Munjal, M. L.
Опубликовано: (2013)

Tuning acoustic performance of multi-chamber hybrid mufflers
по: Van-Hai Trinh
Опубликовано: (2021-07-01)

Parameter study on the performance of muffler /
по: 290332 Abdull Rahim Abu Bakar
Опубликовано: (2005)

Acoustic Efficiency Rating of Mufflers
по: Saulkina Olga, и др.
Опубликовано: (2020-01-01)

Study of the combined muffler effectiveness
по: Chichvarina Kristina, и др.
Опубликовано: (2020-01-01)

Numerical optimization of straight multi-array side-branched mufflers using differential evolution method
по: Min-Chie Chiu
Опубликовано: (2018-06-01)

Parameter study on the performance of muffler [microfilm] /
Опубликовано: (2005)

Simulation and experimental investigation of muffler performance
по: Mohiuddin, A. K. M., и др.
Опубликовано: (2007)

Experimental investigation and simulation of muffler performance
по: Mohiuddin, A. K. M., и др.
Опубликовано: (2007)

Engineering of a CMC aeronautical muffler
по: Marco Riva, и др.
Опубликовано: (2024-07-01)

Muffler design optimization through experimental analysis of noise and back pressure
по: Mohiuddin, A. K. M., и др.
Опубликовано: (2005)

Effect of exhaust thermal parameters on optimal circuit layouts and optimal thermoelectric generator structure used in internal combustion engine
по: Wei He, и др.
Опубликовано: (2023-07-01)

Optimization of four-Chamber and eccentric ellipse mufflers hybridized with multi-Segment perforated/non-perforated tubes
по: Min-Chie Chiu, и др.
Опубликовано: (2023-06-01)

Influence of partition layouts on speech privacy in open-plan offices
по: Seung-Min Lee, и др.
Опубликовано: (2024-09-01)

Parameter study on the performance of muffler [compact disc] /
по: 290332 Abdull Rahim Abu Bakar
Опубликовано: (2005)

SIMULATION FOR THE PRESSURE LOSS OF AUTOMOTIVE EXHAUST MUFFLER
по: WANG ZhiJie, и др.
Опубликовано: (2015-01-01)

Experimental study of optimization of thermoelectric modules’ number and layout for waste heat recovery
по: Xiangrong Ma, и др.
Опубликовано: (2024-05-01)

Study on the Optimized Muffler with Function of PM Filtration for Non-Road Diesel Engines
по: Long Feng, и др.
Опубликовано: (2022-02-01)

Local Structural Optimization Method Based on Orthogonal Analysis for a Resistant Muffler
по: Rui Li, и др.
Опубликовано: (2021-01-01)

Research on Module Layout and Module Coverage of an Automobile Exhaust Thermoelectric Power Generation System
по: Weiqi Zhou, и др.
Опубликовано: (2022-01-01)

Experimental analysis of noise and back pressure for muffler design
по: Mohiuddin, A. K. M., и др.
Опубликовано: (2008)

Three-pass perforated tube muffler with perforated bulkheads
по: Yiliang Fan, и др.
Опубликовано: (2016-11-01)

Investigation of baffle configuration effect on the performance of exhaust mufflers
по: Ahmed Elsayed, и др.
Опубликовано: (2017-09-01)

Acoustic performance of industrial mufflers with CAE modeling and simulation
по: Jeon Soohong, и др.
Опубликовано: (2014-12-01)

Structural Optimization of a Muffler for a Marine Pumping System Based on Numerical Calculation
по: Houlin Liu, и др.
Опубликовано: (2022-07-01)

Optimizing the Muffler of a Portable Lawn Mower Engine to reduce Noise Pollution Levels
по: Sh Sedighi, и др.
Опубликовано: (2021-09-01)

Bending Fatigue Strength and the Effect of Assembling Stress on Fillet Welded Joints of Catalyst Muffler Flange Pipes
по: Gyoko Oh
Опубликовано: (2017-04-01)

Acoustics of ducts and mufflers with application to exhaust and ventilation system design/
по: 206483 Munjal, M. L.
Опубликовано: (1987)

Organized Computational Measurement to Design a High-Performance Muffler
по: Mehran Saadabadi, и др.
Опубликовано: (2023-07-01)

Factors that Influence to Sustainability of MSME Muffler Industry in Purbalingga Regency
по: Faizal Kurniawan, и др.
Опубликовано: (2020-09-01)

Barrier-free duct muffler for low-frequency sound absorption
по: Cong Gao, и др.
Опубликовано: (2022-09-01)

Muffler structure improvement based on acoustic finite element analysis
по: Jun Fu, и др.
Опубликовано: (2019-06-01)

Integrated optimization of thermoelectric systems
по: Schlenker, Aaron Paul.
Опубликовано: (2020)

Exhaust System Muffler Volume Optimization of Light Commercial passenger Car Using Transfer Matrix Method
по: Barhm Mohamad, и др.
Опубликовано: (2019-03-01)

A comparison between hybrid method technique and transfer matrix method for design optimization of vehicle muffler
по: Mohamad Barhm, и др.
Опубликовано: (2021-01-01)

Pemanfaatan Panas Buang di Muffler Kendaraan Roda Dua untuk Pembangkitan Listrik Menggunakan Thermoelektrik Generator
по: Sugiyanto, Sugiyanto, и др.
Опубликовано: (2011)

Design of phononic crystal for enhancing low-frequency sound absorption in mufflers
по: Yang Bai, и др.
Опубликовано: (2024-11-01)

Theoretical and Experimental Study on the Transmission Loss of a Side Outlet Muffler
по: Liang Zhang, и др.
Опубликовано: (2020-01-01)

Law Enforcement of Motorized Vehicles with Muffler Racing by Magelang City Police
по: Damas Reza Kurniadi
Опубликовано: (2020-01-01)