| Summary: | When people think of power electronics applications for wide-bandgap semiconductor
materials, they often consider silicon carbide or gallium nitride. This is not surprising,
as silicon carbide and gallium nitride are the wideband gap semiconductors used in the
world's most advanced power electronics applications. However, for the fabrication of
Micro-strip SiC HEMT, the interconnection of the source part is always a critical problem.
Fortunately, Via-hole processes for the backside of SiC substrate is a proved method
which can ground source region together under the bottom, Therefore, It can improve
the performance of Microwave transmission and save the design space for the other
interconnections. From this project, you would understand how this interconnection
was fabricated in the clean room by a few processes like Lapping for SiC material,
CMP for smooth and uniform surface, Ni plating for the hard mask, SiC dry etching for
Via-hole. Other than that, there are also a few continuous improvements for the above
processes. My project will mainly concentrate on the fabrication of the SiC lapping
and Via-hold dry etching. Specific details for each step will be introduced in the
following chapters.
|
|---|