Novel superconducting joints for persistent mode magnet applications

Novel superconducting joints for persistent mode magnet applications

<p>Persistent current joints are a critical component of commercial superconducting magnets.The standard jointing method widely used in the magnet industry for technological low temperature superconducting wires such as NbTi and Nb3Sn wires uses a superconducting solder (e.g. PbBi). In these j...

Descripció completa

Dades bibliogràfiques
Autors principals:	Speller, S, Mousavi, T, Grovenor, C, Darby, W, Aksoy, C, Davies, T, Brittles, G
Format:	Journal article
Publicat:	Cambridge University Press 2016

Ítems similars

Lead-free solders for superconducting applications
per: Aksoy, C, et al.
Publicat: (2016)

Rapid characterisation of persistent current joints by SQUID magnetometry
per: Brittles, G, et al.
Publicat: (2014)

Persistent current joints between NbTi superconducting wires
per: Brittles, G
Publicat: (2016)

Microstructural properties and magnetic testing of spot-welded joints between Nb-Ti filaments
per: Brittles, GD, et al.
Publicat: (2016)

Microstructure and superconducting properties of Sn–In and Sn–In–Bi alloys as Pb-free superconducting solders
per: Mousavi, T, et al.
Publicat: (2015)

Development of superconducting soldered joints between Bi-2212/Ag wires
per: Mousavi, T, et al.
Publicat: (2018)

Development of superconducting soldered joints between Bi-2212/Ag wires
per: Mousavi, T, et al.
Publicat: (2018)

Phase evolution of superconducting Sn–In–Bi solder alloys
per: Mousavi, T, et al.
Publicat: (2016)

In-situ measurements of the effect of radiation damage on the superconducting properties of coated conductors
per: Grovenor, C, et al.
Publicat: (2021)

Superconducting joint structures for Bi-2212 wires using a powder-in-tube technique
per: Mousavi, T, et al.
Publicat: (2021)

Structural parameters affecting superconductivity in iron chalcogenides: A review
per: Mousavi, T, et al.
Publicat: (2014)

The effect of in situ irradiation on the superconducting performance of REBa2Cu3O7−δ-coated conductors
per: Iliffe, W, et al.
Publicat: (2023)

The effect of the size of NbTi filaments on interfacial reactions and the properties of InSn-based superconducting solder joints
per: Santra, S, et al.
Publicat: (2019)

The effect of the size of NbTi filaments on interfacial reactions and the properties of InSn-based superconducting solder joints
per: S. Santra, et al.
Publicat: (2019-08-01)

In-situ measurements of the effect of radiation damage on the superconducting properties of coated conductors.
per: Grovenor, C, et al.
Publicat: (2021)

X-Ray Computed Tomography Study of the Microstructure of Superconducting MgB 2 Bulks
per: Wang, Y, et al.
Publicat: (2025)

Magnetic imaging of antiferromagnetic and superconducting phases in RbxFe2-ySe2 crystals
per: Speller, S, et al.
Publicat: (2018)

Comparison of the microstructure and superconducting properties of EuBaCuO and GdBaCuO single grain samples
per: Mousavi, T, et al.
Publicat: (2022)

Growth of Tl2Ba2CaCu2O8 superconducting thin films on curved substrates for metamaterials applications
per: Speller, S, et al.
Publicat: (2008)

A new approach to fabricate superconducting NbTi alloys
per: Mousavi, T, et al.
Publicat: (2017)

Calculation of persistent currents in superconducting magnets
per: C. Völlinger, et al.
Publicat: (2000-12-01)

Demonstration of better superconducting performance in a solder with low lead content
per: Aksoy, C, et al.
Publicat: (2022)

Correlation between microstructure and superconducting properties of MgB2 bulk samples with Mg and hBN co-additions
per: Zilin Gao, et al.
Publicat: (2023)

A new approach to fabricate superconducting NbTi alloys
per: Mousavi, T, et al.
Publicat: (2017)

Analytical microscopy of iron-based superconducting materials
per: Speller, S, et al.
Publicat: (2015)

Control of texture in Ag and Ag-alloy substrates for superconducting tapes
per: Gladstone, T, et al.
Publicat: (2000)

Mitigation of persistent current effects in the RHIC superconducting magnets
per: C. Liu, et al.
Publicat: (2019-11-01)

Microstructure of superconducting hetero-joints between single-grained Gd-Ba-Cu-O bulk superconductors
per: Speller, S
Publicat: (2024)

Fabrication of Li1+xAlxGe2-x(PO4)3 thin films by sputtering for solid electrolytes
per: Mousavi, T, et al.
Publicat: (2020)

Development of persistent joints for superconducting Bi-2212 coils
per: Zagura, P
Publicat: (2024)

7 T Niobium-Titanium-Based Persistent-Mode Superconducting Magnet for an Electron Beam Ion Source
per: Su-Hun Kim, et al.
Publicat: (2022-01-01)

Correlation between microstructure and superconducting properties of MgB2 bulk samples with Mg addition and Mg/hBN co-additions
per: Gao, Z, et al.
Publicat: (2023)

Atmospheric oxidation of NbTi superconductor
per: Davies, T, et al.
Publicat: (2020)

Effect of the sintering temperature on the microstructure and superconducting properties of MgB2 bulks manufactured by the field assisted sintering technique
per: Matthews, GAB, et al.
Publicat: (2020)

Microstructures and superconducting properties of MgB2 bulk samples processed by ultra-high pressure-assisted sintering
per: Gao, Z, et al.
Publicat: (2022)

Magnetic imaging of antiferromagnetic and superconducting phases in RbxFe2−ySe2 crystals
per: Hazi, J, et al.
Publicat: (2018)

Industrial applications for superconducting magnets /
per: 294964 Hadlow, M. E., et al.
Publicat: (1974)

New nanoscale artificial pinning centres for NbTi superconductors
per: Mousavi, T, et al.
Publicat: (2020)

Development of superconducting soldered joints between BI-2212/AG wires
per: Mousavi, T
Publicat: (2018)

Research Progresses Concerning the Superconducting Joints Used in Nuclear Magnetic Resonance Magnets
per: Xing HUANG, et al.
Publicat: (2021-09-01)