Novel superconducting joints for persistent mode magnet applications

Novel superconducting joints for persistent mode magnet applications

<p>Persistent current joints are a critical component of commercial superconducting magnets.The standard jointing method widely used in the magnet industry for technological low temperature superconducting wires such as NbTi and Nb3Sn wires uses a superconducting solder (e.g. PbBi). In these j...

पूर्ण विवरण

ग्रंथसूची विवरण
मुख्य लेखकों:	Speller, S, Mousavi, T, Grovenor, C, Darby, W, Aksoy, C, Davies, T, Brittles, G
स्वरूप:	Journal article
प्रकाशित:	Cambridge University Press 2016

समान संसाधन

Lead-free solders for superconducting applications
द्वारा: Aksoy, C, और अन्य
प्रकाशित: (2016)

Rapid characterisation of persistent current joints by SQUID magnetometry
द्वारा: Brittles, G, और अन्य
प्रकाशित: (2014)

Persistent current joints between NbTi superconducting wires
द्वारा: Brittles, G
प्रकाशित: (2016)

Microstructural properties and magnetic testing of spot-welded joints between Nb-Ti filaments
द्वारा: Brittles, GD, और अन्य
प्रकाशित: (2016)

Microstructure and superconducting properties of Sn–In and Sn–In–Bi alloys as Pb-free superconducting solders
द्वारा: Mousavi, T, और अन्य
प्रकाशित: (2015)

Development of superconducting soldered joints between Bi-2212/Ag wires
द्वारा: Mousavi, T, और अन्य
प्रकाशित: (2018)

Development of superconducting soldered joints between Bi-2212/Ag wires
द्वारा: Mousavi, T, और अन्य
प्रकाशित: (2018)

Phase evolution of superconducting Sn–In–Bi solder alloys
द्वारा: Mousavi, T, और अन्य
प्रकाशित: (2016)

In-situ measurements of the effect of radiation damage on the superconducting properties of coated conductors
द्वारा: Grovenor, C, और अन्य
प्रकाशित: (2021)

Superconducting joint structures for Bi-2212 wires using a powder-in-tube technique
द्वारा: Mousavi, T, और अन्य
प्रकाशित: (2021)

Structural parameters affecting superconductivity in iron chalcogenides: A review
द्वारा: Mousavi, T, और अन्य
प्रकाशित: (2014)

The effect of in situ irradiation on the superconducting performance of REBa2Cu3O7−δ-coated conductors
द्वारा: Iliffe, W, और अन्य
प्रकाशित: (2023)

The effect of the size of NbTi filaments on interfacial reactions and the properties of InSn-based superconducting solder joints
द्वारा: Santra, S, और अन्य
प्रकाशित: (2019)

The effect of the size of NbTi filaments on interfacial reactions and the properties of InSn-based superconducting solder joints
द्वारा: S. Santra, और अन्य
प्रकाशित: (2019-08-01)

In-situ measurements of the effect of radiation damage on the superconducting properties of coated conductors.
द्वारा: Grovenor, C, और अन्य
प्रकाशित: (2021)

X-Ray Computed Tomography Study of the Microstructure of Superconducting MgB 2 Bulks
द्वारा: Wang, Y, और अन्य
प्रकाशित: (2025)

Magnetic imaging of antiferromagnetic and superconducting phases in RbxFe2-ySe2 crystals
द्वारा: Speller, S, और अन्य
प्रकाशित: (2018)

Comparison of the microstructure and superconducting properties of EuBaCuO and GdBaCuO single grain samples
द्वारा: Mousavi, T, और अन्य
प्रकाशित: (2022)

Growth of Tl2Ba2CaCu2O8 superconducting thin films on curved substrates for metamaterials applications
द्वारा: Speller, S, और अन्य
प्रकाशित: (2008)

A new approach to fabricate superconducting NbTi alloys
द्वारा: Mousavi, T, और अन्य
प्रकाशित: (2017)

Calculation of persistent currents in superconducting magnets
द्वारा: C. Völlinger, और अन्य
प्रकाशित: (2000-12-01)

Demonstration of better superconducting performance in a solder with low lead content
द्वारा: Aksoy, C, और अन्य
प्रकाशित: (2022)

Correlation between microstructure and superconducting properties of MgB2 bulk samples with Mg and hBN co-additions
द्वारा: Zilin Gao, और अन्य
प्रकाशित: (2023)

A new approach to fabricate superconducting NbTi alloys
द्वारा: Mousavi, T, और अन्य
प्रकाशित: (2017)

Analytical microscopy of iron-based superconducting materials
द्वारा: Speller, S, और अन्य
प्रकाशित: (2015)

Control of texture in Ag and Ag-alloy substrates for superconducting tapes
द्वारा: Gladstone, T, और अन्य
प्रकाशित: (2000)

Mitigation of persistent current effects in the RHIC superconducting magnets
द्वारा: C. Liu, और अन्य
प्रकाशित: (2019-11-01)

Microstructure of superconducting hetero-joints between single-grained Gd-Ba-Cu-O bulk superconductors
द्वारा: Speller, S
प्रकाशित: (2024)

Fabrication of Li1+xAlxGe2-x(PO4)3 thin films by sputtering for solid electrolytes
द्वारा: Mousavi, T, और अन्य
प्रकाशित: (2020)

Development of persistent joints for superconducting Bi-2212 coils
द्वारा: Zagura, P
प्रकाशित: (2024)

7 T Niobium-Titanium-Based Persistent-Mode Superconducting Magnet for an Electron Beam Ion Source
द्वारा: Su-Hun Kim, और अन्य
प्रकाशित: (2022-01-01)

Correlation between microstructure and superconducting properties of MgB2 bulk samples with Mg addition and Mg/hBN co-additions
द्वारा: Gao, Z, और अन्य
प्रकाशित: (2023)

Atmospheric oxidation of NbTi superconductor
द्वारा: Davies, T, और अन्य
प्रकाशित: (2020)

Effect of the sintering temperature on the microstructure and superconducting properties of MgB2 bulks manufactured by the field assisted sintering technique
द्वारा: Matthews, GAB, और अन्य
प्रकाशित: (2020)

Microstructures and superconducting properties of MgB2 bulk samples processed by ultra-high pressure-assisted sintering
द्वारा: Gao, Z, और अन्य
प्रकाशित: (2022)

Magnetic imaging of antiferromagnetic and superconducting phases in RbxFe2−ySe2 crystals
द्वारा: Hazi, J, और अन्य
प्रकाशित: (2018)

Industrial applications for superconducting magnets /
द्वारा: 294964 Hadlow, M. E., और अन्य
प्रकाशित: (1974)

New nanoscale artificial pinning centres for NbTi superconductors
द्वारा: Mousavi, T, और अन्य
प्रकाशित: (2020)

Development of superconducting soldered joints between BI-2212/AG wires
द्वारा: Mousavi, T
प्रकाशित: (2018)

Research Progresses Concerning the Superconducting Joints Used in Nuclear Magnetic Resonance Magnets
द्वारा: Xing HUANG, और अन्य
प्रकाशित: (2021-09-01)