Novel superconducting joints for persistent mode magnet applications

Novel superconducting joints for persistent mode magnet applications

<p>Persistent current joints are a critical component of commercial superconducting magnets.The standard jointing method widely used in the magnet industry for technological low temperature superconducting wires such as NbTi and Nb3Sn wires uses a superconducting solder (e.g. PbBi). In these j...

Bibliografski detalji
Glavni autori:	Speller, S, Mousavi, T, Grovenor, C, Darby, W, Aksoy, C, Davies, T, Brittles, G
Format:	Journal article
Izdano:	Cambridge University Press 2016

Slični predmeti

Lead-free solders for superconducting applications
od: Aksoy, C, i dr.
Izdano: (2016)

Rapid characterisation of persistent current joints by SQUID magnetometry
od: Brittles, G, i dr.
Izdano: (2014)

Persistent current joints between NbTi superconducting wires
od: Brittles, G
Izdano: (2016)

Microstructural properties and magnetic testing of spot-welded joints between Nb-Ti filaments
od: Brittles, GD, i dr.
Izdano: (2016)

Microstructure and superconducting properties of Sn–In and Sn–In–Bi alloys as Pb-free superconducting solders
od: Mousavi, T, i dr.
Izdano: (2015)

Development of superconducting soldered joints between Bi-2212/Ag wires
od: Mousavi, T, i dr.
Izdano: (2018)

Development of superconducting soldered joints between Bi-2212/Ag wires
od: Mousavi, T, i dr.
Izdano: (2018)

Phase evolution of superconducting Sn–In–Bi solder alloys
od: Mousavi, T, i dr.
Izdano: (2016)

In-situ measurements of the effect of radiation damage on the superconducting properties of coated conductors
od: Grovenor, C, i dr.
Izdano: (2021)

Superconducting joint structures for Bi-2212 wires using a powder-in-tube technique
od: Mousavi, T, i dr.
Izdano: (2021)

Structural parameters affecting superconductivity in iron chalcogenides: A review
od: Mousavi, T, i dr.
Izdano: (2014)

The effect of in situ irradiation on the superconducting performance of REBa2Cu3O7−δ-coated conductors
od: Iliffe, W, i dr.
Izdano: (2023)

The effect of the size of NbTi filaments on interfacial reactions and the properties of InSn-based superconducting solder joints
od: Santra, S, i dr.
Izdano: (2019)

The effect of the size of NbTi filaments on interfacial reactions and the properties of InSn-based superconducting solder joints
od: S. Santra, i dr.
Izdano: (2019-08-01)

In-situ measurements of the effect of radiation damage on the superconducting properties of coated conductors.
od: Grovenor, C, i dr.
Izdano: (2021)

X-Ray Computed Tomography Study of the Microstructure of Superconducting MgB 2 Bulks
od: Wang, Y, i dr.
Izdano: (2025)

Magnetic imaging of antiferromagnetic and superconducting phases in RbxFe2-ySe2 crystals
od: Speller, S, i dr.
Izdano: (2018)

Comparison of the microstructure and superconducting properties of EuBaCuO and GdBaCuO single grain samples
od: Mousavi, T, i dr.
Izdano: (2022)

Growth of Tl2Ba2CaCu2O8 superconducting thin films on curved substrates for metamaterials applications
od: Speller, S, i dr.
Izdano: (2008)

A new approach to fabricate superconducting NbTi alloys
od: Mousavi, T, i dr.
Izdano: (2017)

Calculation of persistent currents in superconducting magnets
od: C. Völlinger, i dr.
Izdano: (2000-12-01)

Demonstration of better superconducting performance in a solder with low lead content
od: Aksoy, C, i dr.
Izdano: (2022)

Correlation between microstructure and superconducting properties of MgB2 bulk samples with Mg and hBN co-additions
od: Zilin Gao, i dr.
Izdano: (2023)

A new approach to fabricate superconducting NbTi alloys
od: Mousavi, T, i dr.
Izdano: (2017)

Analytical microscopy of iron-based superconducting materials
od: Speller, S, i dr.
Izdano: (2015)

Control of texture in Ag and Ag-alloy substrates for superconducting tapes
od: Gladstone, T, i dr.
Izdano: (2000)

Mitigation of persistent current effects in the RHIC superconducting magnets
od: C. Liu, i dr.
Izdano: (2019-11-01)

Microstructure of superconducting hetero-joints between single-grained Gd-Ba-Cu-O bulk superconductors
od: Speller, S
Izdano: (2024)

Fabrication of Li1+xAlxGe2-x(PO4)3 thin films by sputtering for solid electrolytes
od: Mousavi, T, i dr.
Izdano: (2020)

Development of persistent joints for superconducting Bi-2212 coils
od: Zagura, P
Izdano: (2024)

7 T Niobium-Titanium-Based Persistent-Mode Superconducting Magnet for an Electron Beam Ion Source
od: Su-Hun Kim, i dr.
Izdano: (2022-01-01)

Correlation between microstructure and superconducting properties of MgB2 bulk samples with Mg addition and Mg/hBN co-additions
od: Gao, Z, i dr.
Izdano: (2023)

Atmospheric oxidation of NbTi superconductor
od: Davies, T, i dr.
Izdano: (2020)

Effect of the sintering temperature on the microstructure and superconducting properties of MgB2 bulks manufactured by the field assisted sintering technique
od: Matthews, GAB, i dr.
Izdano: (2020)

Microstructures and superconducting properties of MgB2 bulk samples processed by ultra-high pressure-assisted sintering
od: Gao, Z, i dr.
Izdano: (2022)

Magnetic imaging of antiferromagnetic and superconducting phases in RbxFe2−ySe2 crystals
od: Hazi, J, i dr.
Izdano: (2018)

Industrial applications for superconducting magnets /
od: 294964 Hadlow, M. E., i dr.
Izdano: (1974)

New nanoscale artificial pinning centres for NbTi superconductors
od: Mousavi, T, i dr.
Izdano: (2020)

Development of superconducting soldered joints between BI-2212/AG wires
od: Mousavi, T
Izdano: (2018)

Research Progresses Concerning the Superconducting Joints Used in Nuclear Magnetic Resonance Magnets
od: Xing HUANG, i dr.
Izdano: (2021-09-01)