The mechanical response of commercially pure copper under multiaxial loading at low and high strain rates

The mechanical response of commercially pure copper under multiaxial loading at low and high strain rates

In this paper, we present the dynamic response of commercially pure copper subjected to combined tension-torsion loads representative of real case impact scenarios. Experiments were conducted both quasi statically, at a strain rate equal to 10−3 s−1, and dynamically at strain rates in the region bet...

Disgrifiad llawn

Manylion Llyfryddiaeth
Prif Awduron:	Zhou, J, Xu, Y, Lopez, MA, Farbaniec, L, Patsias, S, Macdougall, D, Reed, J, Petrinic, N, Eakins, D, Siviour, C, Pellegrino, A
Fformat:	Journal article
Iaith:	English
Cyhoeddwyd:	Elsevier 2022

Eitemau Tebyg

Experimental analysis of the multiaxial failure stress locus of commercially pure titanium at low and high rates of strain
gan: Xu, Y, et al.
Cyhoeddwyd: (2022)

Application of the Photon Doppler Velocimetry (PDV) technique in tension-torsion Hopkinson bar experiments
gan: Farbaniec, L, et al.
Cyhoeddwyd: (2021)

Application of the Photon Doppler Velocimetry (PDV) technique in tension-torsion Hopkinson bar experiments
gan: Farbaniec Lukasz, et al.
Cyhoeddwyd: (2021-01-01)

The development of split Hopkinson tension-torsion bar for the understanding of complex stress states at high rate
gan: Xu, Y, et al.
Cyhoeddwyd: (2021)

Strain rate dependent compressive properties of glass microballoon epoxy syntactic foams
gan: Li, P, et al.
Cyhoeddwyd: (2009)

Measurement of pure shear constitutive relationship from torsion tests under quasi-static, medium, and high strain rate conditions
gan: Zhang, L, et al.
Cyhoeddwyd: (2021)

Mechanical behaviour of rapidly solidified copper: effects of undercooling and strain rate
gan: Dragnevski, KI, et al.
Cyhoeddwyd: (2019)

Strain rate dependence of a super-elastic NiTi alloy
gan: Siviour, C, et al.
Cyhoeddwyd: (2009)

The Strain Rate Dependent Material Behavior of S-GFRP Extracted from GLARE
gan: Gerlach, R, et al.
Cyhoeddwyd: (2013)

Compressive deformation of Rohacell foams: Effects of strain rate and temperature
gan: Arezoo, S, et al.
Cyhoeddwyd: (2013)

SPECIAL ISSUE ON HIGH STRAIN RATE AND IMPACT LOADING
gan: Siviour, C
Cyhoeddwyd: (2010)

Spatially resolved measurements of grain size effects on the shock and spall response of quasi-Taylor wave loaded pure copper
gan: Whiteman, G, et al.
Cyhoeddwyd: (2017)

TEXTURE DEPENDENCY OF HIGH STRAIN RATE PROPERTIES OF Ti-6Al-4V
gan: Wielewski, E, et al.
Cyhoeddwyd: (2009)

Pure shear plastic flow and failure of titanium alloys under quasi-static and dynamic torsional loading
gan: Zhang, L, et al.
Cyhoeddwyd: (2022)

Biaxial Tensile Behavior of Commercially Pure Titanium under Various In-Plane Load Ratios and Strain Rates
gan: Wei Zhang, et al.
Cyhoeddwyd: (2021-01-01)

On the correlation between macrozones and twinning in Ti-6Al-4V at very high strain rates
gan: Wielewski, E, et al.
Cyhoeddwyd: (2012)

The Effect of Strain Rate, Specimen Geometry and Lubrication on Responses of Aluminium AA2024 in Uniaxial Compression Experiments
gan: Li, P, et al.
Cyhoeddwyd: (2009)

Temperature dependent dynamic compressive response of PA66-GF30 composite under constant strain rate multiaixal loading
gan: Zhang, L, et al.
Cyhoeddwyd: (2022)

An integrated experimental-numerical method for characterisation of materials at high strain rates
gan: Elliott, B, et al.
Cyhoeddwyd: (2007)

Experimental characterisation of the strain rate dependent failure and damage behaviour of 3D composites
gan: Gerlach, R, et al.
Cyhoeddwyd: (2009)

Improved materials characterisation through the application of geometry reconstruction to quasi-static and high-strain-rate tension tests
gan: Arthington, M, et al.
Cyhoeddwyd: (2012)

Notched graphite under multiaxial loading
gan: S.M.J. Razavi, et al.
Cyhoeddwyd: (2017-07-01)

Notched graphite under multiaxial loading
gan: S.M.J. Razavi, et al.
Cyhoeddwyd: (2017-06-01)

Fatigue under biaxial and multiaxial loading /
gan: International Conference on Biaxial/Multiaxial Fatigue (3rd : 1989 : University of Stuttgart, Germany), et al.
Cyhoeddwyd: (1991)

A comparison of methods for calculating notch tip strains and stresses under multiaxial loading
gan: M. Lutovinov, et al.
Cyhoeddwyd: (2016-10-01)

A comparison of methods for calculating notch tip strains and stresses under multiaxial loading
gan: M. Lutovinov, et al.
Cyhoeddwyd: (2016-10-01)

Effects of Strain Rate on the GND Characteristics of Deformed Polycrystalline Pure Copper
gan: Yidan Ma, et al.
Cyhoeddwyd: (2024-05-01)

Effect of oxygen contents on strain rate sensitivity of commercially pure titanium
gan: Lee Min-Su, et al.
Cyhoeddwyd: (2020-01-01)

Influence of strain history on dynamic strain localization and stress state during high-rate tensile loading of titanium alloys: experiments, modelling and analytical methods
gan: Gour, G, et al.
Cyhoeddwyd: (2022)

Improved predictive modelling of strain localisation and ductile fracture in a Ti-6Al-4V alloy subjected to impact loading
gan: Petrinic, N, et al.
Cyhoeddwyd: (2006)

Measurements of the effects of pure and salt water absorption on the rate-dependent response of an epoxy matrix
gan: Quino, G, et al.
Cyhoeddwyd: (2018)

Strain rate and temperature dependent strain localization of dynamically stretched lightweight bars: from metal to polymer
gan: Zhang, L, et al.
Cyhoeddwyd: (2021)

Evaluation and visualization of multiaxial stress and strain states under non-proportional loading
gan: M. Sakane, et al.
Cyhoeddwyd: (2015-07-01)

Evaluation and visualization of multiaxial stress and strain states under non-proportional loading
gan: T. Itoh, et al.
Cyhoeddwyd: (2015-06-01)

Strain-rate and off-axis loading effects on the fibre compression strength of CFRP laminates: experiments and constitutive modelling
gan: Thomson, D, et al.
Cyhoeddwyd: (2020)

Thermoreflectance-based approach for surface temperature measurements of thin-film gold sensors
gan: Farbaniec, L, et al.
Cyhoeddwyd: (2023)

Strain rate dependence of Ti64: Characterisation of mechanical properties up to failure using novel optical techniques
gan: Arthington, M, et al.
Cyhoeddwyd: (2009)

Stress-strain and microscopy data for fire-damaged aluminum alloy 6061 subjected to multiaxial loading
gan: S.B. Puplampu, et al.
Cyhoeddwyd: (2021-10-01)

Experimental and numerical study of high strain rate property of pure copper processed by ECAE method
gan: Sulaiman, S., et al.
Cyhoeddwyd: (2019)

Composites in extreme environments: effects of high strain rate, humidity and temperature
gan: Quino, G, et al.
Cyhoeddwyd: (2021)