Thermal-fluid-structural analysis of the Oxford High Density Tunnel

Thermal-fluid-structural analysis of the Oxford High Density Tunnel

Modelling of the operation of the Oxford High Density Tunnel (HDT) was performed to establish the level and duration of test gas heating required in the facility and the thermal structural implications of this heating. 1-D gas dynamic simulations of the transient flow conditions in the facility were...

Descripció completa

Dades bibliogràfiques
Autors principals:	Neely, A, McGilvray, M, Calder-Smith, T, Ireland, P
Format:	Conference item
Publicat:	Australasian Fluid Mechanics Society 2014

Ítems similars

The Oxford High Density Tunnel
per: McGilvray, M, et al.
Publicat: (2015)

Refurbishment and characterisation of the Oxford Low Density Hypersonic Wind Tunnel
per: Donaldson, N, et al.
Publicat: (2019)

Commissioning of the Oxford High Density Tunnel (HDT) for boundary layer stability measurements at Mach 7
per: Wylie, S, et al.
Publicat: (2018)

Commissioning Ludwieg mode with isentropic compression heating for the Oxford High Density Tunnel
per: Ivison, W, et al.
Publicat: (2024)

Experimental investigation of boundary layer instabilities and transition on sharp and blunt cones in Oxford’s High-Density Tunnel
per: Ceruzzi, AP, et al.
Publicat: (2024)

T6: The Oxford University Stalker tunnel
per: McGilvray, M, et al.
Publicat: (2015)

T6: The Oxford University Stalker Tunnel
per: McGilvray, M, et al.
Publicat: (2015)

Condition development and commissioning of the Oxford T6 Stalker Tunnel in reflected shock tunnel mode
per: Subiah, S, et al.
Publicat: (2019)

CONDITION DEVELOPMENT AND COMMISSIONING OF THE OXFORD T6 STALKER TUNNEL IN REFLECTED SHOCK TUNNEL MODE - Dataset
per: Hermann, T, et al.
Publicat: (2022)

The Oxford T6 Stalker tunnel: performance, upgrades and new modes of operation
per: McGilvray, M, et al.
Publicat: (2022)

Modelling the complete operation of a free-piston shock tunnel for a low enthalpy condition
per: McGilvray, M, et al.
Publicat: (2013)

Modelling the complete operation of a free-piston shock tunnel for a low enthalpy condition
per: McGilvray, M, et al.
Publicat: (2013)

Extension of test time in Ludwieg tunnels
per: Hillyer, J, et al.
Publicat: (2022)

Enhancing the test time performance of Ludwieg tunnels
per: Hillyer, J, et al.
Publicat: (2024)

The Oxford Cold Driven Shock Tube (CDST) for fuel spray and chemical kinetics research
per: Camm, J, et al.
Publicat: (2018)

Computational study of the effect of inlet velocity profile and rib orientation on heat transfer in rotating ribbed radial turbine cooling passages
per: Pearce, R, et al.
Publicat: (2016)

Stagnation point heat flux measurements in a plasma wind tunnel using a diamond heat transfer gauge
per: Penty Geraets, R, et al.
Publicat: (2019)

Analytical thermal boundary condition for quasi-transient simulation of internal flow experiments
per: Forsyth, PR, et al.
Publicat: (2021)

Commissioning of the T6 Stalker Tunnel
per: Collen, P, et al.
Publicat: (2019)

Fluid-solid heat exchange in porous media for transpiration cooling systems
per: Hermann, T, et al.
Publicat: (2019)

The use of fluid-solid cell transformation to model volcanic ash deposition within a gas turbine hot component
per: Connolly, JP, et al.
Publicat: (2018)

Numerical modelling techniques for turbine blade internal cooling passages
per: Dhopade, P, et al.
Publicat: (2015)

Thermal-fluid coupling analysis of ultra-high voltage cables laid in tunnel
per: LIN Ziqi, et al.
Publicat: (2022-05-01)

Measurements of hypersonic double cone flows with shock wave/boundary layer interactions in the X3 expansion tunnel
per: Kennedy, A, et al.
Publicat: (2023)

Computational and experimental study of heat transfer in rotating ribbed radial turbine cooling passages
per: Pearce, R, et al.
Publicat: (2015)

Thermal impulse response in porous media for transpiration cooling systems
per: Hermann, T, et al.
Publicat: (2020)

Numerical Simulation of Transpiration Cooling for a High-Speed Vehicle with Substructure - Dataset
per: Naved, I, et al.
Publicat: (2022)

Thermal Impulse Response in Porous Media for Transpiration Cooling Systems - Dataset
per: Hermann, T, et al.
Publicat: (2022)

Analytical model of transpired-coolant concentration at downstream wall in high-speed laminar flow
per: Ifti, HS, et al.
Publicat: (2023)

Investigation of fluidic thrust vectoring for scramjets
per: Hambidge, C, et al.
Publicat: (2023)

Numerical simulation of transpiration cooling for a high speed vehicle with substructure
per: Naved, I, et al.
Publicat: (2021)

Emission spectroscopy of low density air shock tube flows above 10 km/s
per: Hermann, T, et al.
Publicat: (2022)

Analytical solution of flows in porous media for transpiration cooling applications
per: Hermann, T, et al.
Publicat: (2021)

Analytical Solution of Flows in Porous Media for Transpiration Cooling Applications - Dataset
per: Hermann, T, et al.
Publicat: (2022)

The stability of coefficients in an Irish inter-industry model/
per: 453711 McGilvray, J.

Expansion tunnel radiation experiments to support hayabusa re-entry observations
per: Buttsworth, D, et al.
Publicat: (2010)

Development and commissioning of the T6 Stalker Tunnel
per: Collen, P, et al.
Publicat: (2021)

Thermal effects of plume impingement on a hypersonic vehicle
per: Hillyer, J, et al.
Publicat: (2022)

Simulation of high mach number scramjet flow conditions using the X2 expansion tube
per: Gildfind, D, et al.
Publicat: (2012)

Three-dimensional focusing schlieren using a plenoptic camera
per: Kerth, P, et al.
Publicat: (2019)