Thermal-fluid-structural analysis of the Oxford High Density Tunnel

Thermal-fluid-structural analysis of the Oxford High Density Tunnel

Modelling of the operation of the Oxford High Density Tunnel (HDT) was performed to establish the level and duration of test gas heating required in the facility and the thermal structural implications of this heating. 1-D gas dynamic simulations of the transient flow conditions in the facility were...

Full description

Bibliographic Details
Main Authors:	Neely, A, McGilvray, M, Calder-Smith, T, Ireland, P
Format:	Conference item
Published:	Australasian Fluid Mechanics Society 2014

Similar Items

The Oxford High Density Tunnel
by: McGilvray, M, et al.
Published: (2015)

Refurbishment and characterisation of the Oxford Low Density Hypersonic Wind Tunnel
by: Donaldson, N, et al.
Published: (2019)

Commissioning of the Oxford High Density Tunnel (HDT) for boundary layer stability measurements at Mach 7
by: Wylie, S, et al.
Published: (2018)

Commissioning Ludwieg mode with isentropic compression heating for the Oxford High Density Tunnel
by: Ivison, W, et al.
Published: (2024)

Experimental investigation of boundary layer instabilities and transition on sharp and blunt cones in Oxford’s High-Density Tunnel
by: Ceruzzi, AP, et al.
Published: (2024)

T6: The Oxford University Stalker tunnel
by: McGilvray, M, et al.
Published: (2015)

T6: The Oxford University Stalker Tunnel
by: McGilvray, M, et al.
Published: (2015)

Condition development and commissioning of the Oxford T6 Stalker Tunnel in reflected shock tunnel mode
by: Subiah, S, et al.
Published: (2019)

CONDITION DEVELOPMENT AND COMMISSIONING OF THE OXFORD T6 STALKER TUNNEL IN REFLECTED SHOCK TUNNEL MODE - Dataset
by: Hermann, T, et al.
Published: (2022)

The Oxford T6 Stalker tunnel: performance, upgrades and new modes of operation
by: McGilvray, M, et al.
Published: (2022)

Modelling the complete operation of a free-piston shock tunnel for a low enthalpy condition
by: McGilvray, M, et al.
Published: (2013)

Modelling the complete operation of a free-piston shock tunnel for a low enthalpy condition
by: McGilvray, M, et al.
Published: (2013)

Extension of test time in Ludwieg tunnels
by: Hillyer, J, et al.
Published: (2022)

Enhancing the test time performance of Ludwieg tunnels
by: Hillyer, J, et al.
Published: (2024)

The Oxford Cold Driven Shock Tube (CDST) for fuel spray and chemical kinetics research
by: Camm, J, et al.
Published: (2018)

Computational study of the effect of inlet velocity profile and rib orientation on heat transfer in rotating ribbed radial turbine cooling passages
by: Pearce, R, et al.
Published: (2016)

Stagnation point heat flux measurements in a plasma wind tunnel using a diamond heat transfer gauge
by: Penty Geraets, R, et al.
Published: (2019)

Analytical thermal boundary condition for quasi-transient simulation of internal flow experiments
by: Forsyth, PR, et al.
Published: (2021)

Commissioning of the T6 Stalker Tunnel
by: Collen, P, et al.
Published: (2019)

Fluid-solid heat exchange in porous media for transpiration cooling systems
by: Hermann, T, et al.
Published: (2019)

The use of fluid-solid cell transformation to model volcanic ash deposition within a gas turbine hot component
by: Connolly, JP, et al.
Published: (2018)

Numerical modelling techniques for turbine blade internal cooling passages
by: Dhopade, P, et al.
Published: (2015)

Thermal-fluid coupling analysis of ultra-high voltage cables laid in tunnel
by: LIN Ziqi, et al.
Published: (2022-05-01)

Measurements of hypersonic double cone flows with shock wave/boundary layer interactions in the X3 expansion tunnel
by: Kennedy, A, et al.
Published: (2023)

Computational and experimental study of heat transfer in rotating ribbed radial turbine cooling passages
by: Pearce, R, et al.
Published: (2015)

Thermal impulse response in porous media for transpiration cooling systems
by: Hermann, T, et al.
Published: (2020)

Numerical Simulation of Transpiration Cooling for a High-Speed Vehicle with Substructure - Dataset
by: Naved, I, et al.
Published: (2022)

Thermal Impulse Response in Porous Media for Transpiration Cooling Systems - Dataset
by: Hermann, T, et al.
Published: (2022)

Analytical model of transpired-coolant concentration at downstream wall in high-speed laminar flow
by: Ifti, HS, et al.
Published: (2023)

Investigation of fluidic thrust vectoring for scramjets
by: Hambidge, C, et al.
Published: (2023)

Numerical simulation of transpiration cooling for a high speed vehicle with substructure
by: Naved, I, et al.
Published: (2021)

Emission spectroscopy of low density air shock tube flows above 10 km/s
by: Hermann, T, et al.
Published: (2022)

Analytical solution of flows in porous media for transpiration cooling applications
by: Hermann, T, et al.
Published: (2021)

Analytical Solution of Flows in Porous Media for Transpiration Cooling Applications - Dataset
by: Hermann, T, et al.
Published: (2022)

The stability of coefficients in an Irish inter-industry model/
by: 453711 McGilvray, J.

Expansion tunnel radiation experiments to support hayabusa re-entry observations
by: Buttsworth, D, et al.
Published: (2010)

Development and commissioning of the T6 Stalker Tunnel
by: Collen, P, et al.
Published: (2021)

Thermal effects of plume impingement on a hypersonic vehicle
by: Hillyer, J, et al.
Published: (2022)

Simulation of high mach number scramjet flow conditions using the X2 expansion tube
by: Gildfind, D, et al.
Published: (2012)

Three-dimensional focusing schlieren using a plenoptic camera
by: Kerth, P, et al.
Published: (2019)