Thermal-fluid-structural analysis of the Oxford High Density Tunnel

Thermal-fluid-structural analysis of the Oxford High Density Tunnel

Modelling of the operation of the Oxford High Density Tunnel (HDT) was performed to establish the level and duration of test gas heating required in the facility and the thermal structural implications of this heating. 1-D gas dynamic simulations of the transient flow conditions in the facility were...

Descripción completa

Detalles Bibliográficos
Autores principales:	Neely, A, McGilvray, M, Calder-Smith, T, Ireland, P
Formato:	Conference item
Publicado:	Australasian Fluid Mechanics Society 2014

Ejemplares similares

The Oxford High Density Tunnel
por: McGilvray, M, et al.
Publicado: (2015)

Refurbishment and characterisation of the Oxford Low Density Hypersonic Wind Tunnel
por: Donaldson, N, et al.
Publicado: (2019)

Commissioning of the Oxford High Density Tunnel (HDT) for boundary layer stability measurements at Mach 7
por: Wylie, S, et al.
Publicado: (2018)

Commissioning Ludwieg mode with isentropic compression heating for the Oxford High Density Tunnel
por: Ivison, W, et al.
Publicado: (2024)

Experimental investigation of boundary layer instabilities and transition on sharp and blunt cones in Oxford’s High-Density Tunnel
por: Ceruzzi, AP, et al.
Publicado: (2024)

T6: The Oxford University Stalker tunnel
por: McGilvray, M, et al.
Publicado: (2015)

T6: The Oxford University Stalker Tunnel
por: McGilvray, M, et al.
Publicado: (2015)

Condition development and commissioning of the Oxford T6 Stalker Tunnel in reflected shock tunnel mode
por: Subiah, S, et al.
Publicado: (2019)

CONDITION DEVELOPMENT AND COMMISSIONING OF THE OXFORD T6 STALKER TUNNEL IN REFLECTED SHOCK TUNNEL MODE - Dataset
por: Hermann, T, et al.
Publicado: (2022)

The Oxford T6 Stalker tunnel: performance, upgrades and new modes of operation
por: McGilvray, M, et al.
Publicado: (2022)

Modelling the complete operation of a free-piston shock tunnel for a low enthalpy condition
por: McGilvray, M, et al.
Publicado: (2013)

Modelling the complete operation of a free-piston shock tunnel for a low enthalpy condition
por: McGilvray, M, et al.
Publicado: (2013)

Extension of test time in Ludwieg tunnels
por: Hillyer, J, et al.
Publicado: (2022)

Enhancing the test time performance of Ludwieg tunnels
por: Hillyer, J, et al.
Publicado: (2024)

The Oxford Cold Driven Shock Tube (CDST) for fuel spray and chemical kinetics research
por: Camm, J, et al.
Publicado: (2018)

Computational study of the effect of inlet velocity profile and rib orientation on heat transfer in rotating ribbed radial turbine cooling passages
por: Pearce, R, et al.
Publicado: (2016)

Stagnation point heat flux measurements in a plasma wind tunnel using a diamond heat transfer gauge
por: Penty Geraets, R, et al.
Publicado: (2019)

Analytical thermal boundary condition for quasi-transient simulation of internal flow experiments
por: Forsyth, PR, et al.
Publicado: (2021)

Commissioning of the T6 Stalker Tunnel
por: Collen, P, et al.
Publicado: (2019)

Fluid-solid heat exchange in porous media for transpiration cooling systems
por: Hermann, T, et al.
Publicado: (2019)

The use of fluid-solid cell transformation to model volcanic ash deposition within a gas turbine hot component
por: Connolly, JP, et al.
Publicado: (2018)

Numerical modelling techniques for turbine blade internal cooling passages
por: Dhopade, P, et al.
Publicado: (2015)

Measurements of hypersonic double cone flows with shock wave/boundary layer interactions in the X3 expansion tunnel
por: Kennedy, A, et al.
Publicado: (2023)

Computational and experimental study of heat transfer in rotating ribbed radial turbine cooling passages
por: Pearce, R, et al.
Publicado: (2015)

Thermal impulse response in porous media for transpiration cooling systems
por: Hermann, T, et al.
Publicado: (2020)

Thermal-fluid coupling analysis of ultra-high voltage cables laid in tunnel
por: LIN Ziqi, et al.
Publicado: (2022-05-01)

Numerical Simulation of Transpiration Cooling for a High-Speed Vehicle with Substructure - Dataset
por: Naved, I, et al.
Publicado: (2022)

Thermal Impulse Response in Porous Media for Transpiration Cooling Systems - Dataset
por: Hermann, T, et al.
Publicado: (2022)

Analytical model of transpired-coolant concentration at downstream wall in high-speed laminar flow
por: Ifti, HS, et al.
Publicado: (2023)

Investigation of fluidic thrust vectoring for scramjets
por: Hambidge, C, et al.
Publicado: (2023)

Numerical simulation of transpiration cooling for a high speed vehicle with substructure
por: Naved, I, et al.
Publicado: (2021)

Analytical solution of flows in porous media for transpiration cooling applications
por: Hermann, T, et al.
Publicado: (2021)

Analytical Solution of Flows in Porous Media for Transpiration Cooling Applications - Dataset
por: Hermann, T, et al.
Publicado: (2022)

The stability of coefficients in an Irish inter-industry model/
por: 453711 McGilvray, J.

Emission spectroscopy of low density air shock tube flows above 10 km/s
por: Hermann, T, et al.
Publicado: (2022)

Expansion tunnel radiation experiments to support hayabusa re-entry observations
por: Buttsworth, D, et al.
Publicado: (2010)

Development and commissioning of the T6 Stalker Tunnel
por: Collen, P, et al.
Publicado: (2021)

Thermal effects of plume impingement on a hypersonic vehicle
por: Hillyer, J, et al.
Publicado: (2022)

Simulation of high mach number scramjet flow conditions using the X2 expansion tube
por: Gildfind, D, et al.
Publicado: (2012)

Three-dimensional focusing schlieren using a plenoptic camera
por: Kerth, P, et al.
Publicado: (2019)