Room temperature precipitation in quenched Al-Cu-Mg alloys: a model for the reaction kinetics and yield strength development

Room temperature precipitation in quenched Al-Cu-Mg alloys: a model for the reaction kinetics and yield strength development

التفاصيل البيبلوغرافية
المؤلفون الرئيسيون:	Starink, M, Gao, N, Davin, L, Yan, J, Cerezo, A
التنسيق:	Journal article
منشور في:	2005

مواد مشابهة

Reply to the comments on "Room-temperature precipitation in quenched Al-Cu-Mg alloys: a model for the reaction kinetics and yield-strength development''
حسب: Starink, M, وآخرون
منشور في: (2006)

Characterization of the precipitation in Al-Li-Cu-Mg-(Mn, Zr) alloys
حسب: Davin, L, وآخرون
منشور في: (2004)

Microstructure and precipitation in Al-Li-Cu-Mg-(Mn, Zr) alloys
حسب: Gao, N, وآخرون
منشور في: (2005)

Precipitation in stretched Al-Cu-Mg alloys with reduced alloying content studied by DSC, TEM and atom probe
حسب: Gao, N, وآخرون
منشور في: (2002)

EFFECT OF THE AGEING TEMPERATURE, AGEING TIME AND QUENCHING TEMPERATURE ON PRECIPITATION KINETICS IN Al-Mg-Si ALLOY
حسب: Fatima Z. Lemmadi, وآخرون
منشور في: (2014-12-01)

Quantitative correlation between strength, ductility and precipitate microstructures with PFZ in Al-Zn-Mg(-Ag, Cu) alloys
حسب: Ogura, T, وآخرون
منشور في: (2006)

Early-stage precipitation in Al-Zn-Mg-Cu alloy (7050)
حسب: Sha, G, وآخرون
منشور في: (2004)

Precipitation kinetics of precipitates with different orientations and segregation in an ultrafine grained Al–Cu–Mg alloy
حسب: Linyan Zhang, وآخرون
منشور في: (2024-01-01)

Kinetic Monte Carlo simulation of clustering in an Al-Zn-Mg-Cu alloy(7050)
حسب: Sha, G, وآخرون
منشور في: (2005)

Enhanced aging kinetics in Al-Mg-Si alloys by up-quenching
حسب: Florian Schmid, وآخرون
منشور في: (2021-06-01)

Behavior of Precipitation Kinetics of 7050 Aluminum Alloy Die Forgings in Quenching Processes
حسب: WU Shu-zhou, وآخرون
منشور في: (2018-11-01)

Study of the Precipitation Kinetics, Microstructures, and Mechanical Properties of Al-Zn-Mg-xCu Alloys
حسب: Aiqin Tian, وآخرون
منشور في: (2022-09-01)

Modeling Precipitation Hardening and Yield Strength in Cast Al-Si-Mg-Mn Alloys
حسب: Emre Cinkilic, وآخرون
منشور في: (2020-10-01)

Thermodynamic, Kinetic and Strength Calculation of High Zinc Containing Al-Zn-Mg-Cu Alloys
حسب: Jinsan Wang, وآخرون
منشور في: (2022-01-01)

COMPOSITIONAL STUDIES OF OMEGA-PRECIPITATES AND O'-PRECIPITATES IN AN AL-CU-MG-AG ALLOY
حسب: Shollock, B, وآخرون
منشور في: (1990)

Precipitation of secondary phase in Mg-Zn-Gd alloy after room-temperature deformation and annealing
حسب: Hua Huang, وآخرون
منشور في: (2018-04-01)

Enhanced tensile strength in an Al–Zn–Mg–Cu alloy via engineering the precipitates along the grain boundaries
حسب: Muhammad Abubaker Khan, وآخرون
منشور في: (2023-01-01)

Quantitative evaluation of the effect of Ag-addition on the concurrently-existing precipitation kinetics in the aged Al-Cu-Mg(-Ag) alloys
حسب: Mien-Chung Chen, وآخرون
منشور في: (2023-03-01)

Enhancing homogenous precipitation and strengthening effectiveness in AlCuMg alloy
حسب: W. Chrominski, وآخرون
منشور في: (2024-11-01)

Precipitation behaviors of multi-scale precipitation strengthened Al–Mg–Si–Cu–Zn alloys controlled by Mg content
حسب: Wenyuan Gong, وآخرون
منشور في: (2021-07-01)

Tensile properties of high strength cast Mg alloys at room temperature: A review
حسب: Fu Penghuai, وآخرون
منشور في: (2014-07-01)

Effects of quenching cooling method and macro-orientation on mechanical properties of Al-Zn-Mg-Cu alloys
حسب: LIU Jingxin, وآخرون
منشور في: (2024-09-01)

Effect of Quenching Rate on Microstructure and Hardness of Al-Zn-Mg-Cu-Cr Alloy Extruded Bar
حسب: HAN Su-qi, وآخرون
منشور في: (2017-04-01)

Effects of twin-boundary precipitates on twin stability and yield strength of a Mg-Nd-Ag-Zr alloy
حسب: X.J. Zhao, وآخرون
منشور في: (2024-05-01)

Exceptional reversed yield strength asymmetry in a rare-earth free Mg alloy containing quasicrystal precipitates
حسب: Qiang Yang, وآخرون
منشور في: (2024-02-01)

Insights into precipitation characteristics and strengthening mechanisms in a low Cu/Mg ratio Al-Cu-Mg-Ag alloy
حسب: Qilong Liu, وآخرون
منشور في: (2024-04-01)

Achieving high strength-ductility of an Al–Mg–Si–Cu alloy via heterostructure coupling with pre-aging precipitation
حسب: Shibiao Zhong, وآخرون
منشور في: (2024-05-01)

Enhanced mechanical strength of Cu–Sn alloy by Mg addition
حسب: Tao Wu, وآخرون
منشور في: (2021-01-01)

Al-Zn-Mg-Cu Alloys with Strength of 800MPa
حسب: YANG Shou-jie, وآخرون
منشور في: (2018-04-01)

Residual stress and precipitation of Mg-5Zn-3.5Sn-1Mn-0.5Ea-0.5Cu alloy with different quenching rates
حسب: Cong Wang, وآخرون
منشور في: (2021-03-01)

Aging kinetics of 14H-LPSO precipitates in Mg-Zn-Y alloy
حسب: Di-qing Wan, وآخرون
منشور في: (2020-01-01)

Effect of Mg addition on the crystallization kinetics of Zn-Al-Cu alloys
حسب: Krupiński M., وآخرون
منشور في: (2020-01-01)

Precipitation Kinetics and Evaluation of the Interfacial Mobility of Precipitates in an AlSi7Cu3.5Mg0.15 Cast Alloy with Zr and V Additions
حسب: Pierre Heugue, وآخرون
منشور في: (2019-07-01)

Precipitation behavior during re-aging of Al-Mg-Si-Cu alloy
حسب: Hongmei Jin, وآخرون
منشور في: (2022-08-01)

Rapidly quenched Mg(65)Al(x)CU(25-x)MM(10) (MM : mischmetal) alloys
حسب: Audebert, F, وآخرون
منشور في: (2001)

PHASE CHEMISTRY AND PRECIPITATION REACTIONS IN MARAGING STEELS .3. MODEL ALLOYS
حسب: Sha, W, وآخرون
منشور في: (1993)

Crystallography of precipitates in Mg alloys
حسب: Zhang-Zhi Shi, وآخرون
منشور في: (2021-03-01)

Crystallization Kinetics of Sr-Modified Precipitation Hardening Al-Si-Cu Alloys
حسب: Mariusz Krupiński, وآخرون
منشور في: (2025-01-01)

Atom probe characterization of precipitation in an aged Cu-Ni-P alloy.
حسب: Aruga, Y, وآخرون
منشور في: (2011)

A comparative study on precipitation behavior of a sand-cast Al–Li–Cu alloy with the different quenching rates
حسب: Yixiao Wang, وآخرون
منشور في: (2022-11-01)