The thermal expansion coefficient of mechanically alloyed Al-Cu-Fe quasicrystalline powders

The thermal expansion coefficient of mechanically alloyed Al-Cu-Fe quasicrystalline powders

Näytä muut versiot (1)

Bibliografiset tiedot
Päätekijät:	Korsunsky, A, Salimon, A, Pape, I, Polyakov, A, Fitch, A
Muut tekijät:	Acta Materialia Inc.
Aineistotyyppi:	Journal article
Kieli:	English
Julkaistu:	Pergamon 2001
Aiheet:	Engineering & allied sciences

Samankaltaisia teoksia

The thermal expansion coefficient of mechanically alloyed Al-Cu-Fe quasicrystalline powders
Tekijä: Korsunsky, A, et al.
Julkaistu: (2001)

Crystallochemical aspects of solid state reactions in mechanically alloyed Al-Cu-Fe quasicrystalline powders
Tekijä: Salimon, A, et al.
Julkaistu: (2001)

The evolution of crystalline precursors during the formation of Al-Cu-Fe quasicrystalline intermetallics in mechanically alloyed powders
Tekijä: Salimon, A, et al.
Julkaistu: (2001)

Quasicrystalline phase formation by heating a mechanically alloyed Al65Cu23Fe12 powder mixture
Tekijä: Tcherdyntsev, V, et al.
Julkaistu: (2002)

Preparation and analysis of quasicrystalline phases by high energy ball milling and X-ray diffraction
Tekijä: Salimon, A, et al.
Julkaistu: (2000)

The evolution of crystalline precursors during the formation of Al-Cu-Fe quasicrystalline intermetallics in mechanically alloyed powders
Tekijä: Salimon, A, et al.
Julkaistu: (2001)

Crystallochemical aspects of solid state reactions in mechanically alloyed Al-Cu-Fe quasicrystalline powders
Tekijä: Salimon, A, et al.
Julkaistu: (2001)

Quasicrystalline phase formation by heating a mechanically alloyed Al65Cu23Fe12 powder mixture
Tekijä: Tcherdyntsev, V, et al.
Julkaistu: (2002)

The evolution of electrochemical, microstructural, and mechanical properties of aluminium alloy 2024-T4 (D16AT) during fatigue cycling
Tekijä: Salimon, S, et al.
Julkaistu: (2010)

The character of dislocation structure evolution in nanocrystalline FCC Ni-Co alloys prepared by high-energy mechanical milling
Tekijä: Salimon, A, et al.
Julkaistu: (1999)

Structure and High-Temperature Properties of the Alloyed Quasicrystalline Al-Cu-Fe Powders and Thermal-Sprayed Coatings from Them
Tekijä: Iefimov, M.O., et al.
Julkaistu: (2006-04-01)

Dissipated energy and friction coefficient evolution during fretting wear of solid lubricant coatings
Tekijä: Korsunsky, A, et al.
Julkaistu: (2009)

Strengthening mechanisms in an Al-Fe-Cr-Ti nano-quasicrystalline alloy and composites
Tekijä: Pedrazzini, S, et al.
Julkaistu: (2016)

Quasicrystalline Phase Formation of the Al67Cu26Fe15 Alloy
Tekijä: Luciano Nascimento, et al.
Julkaistu: (2019-06-01)

Strengthening mechanisms in an Al-Fe-Cr-Ti nano-quasicrystalline alloy and composites
Tekijä: Pedrazzini, S, et al.
Julkaistu: (2016)

Variational eigenstrain analysis of synchrotron diffraction measurements of residual elastic strain in a bent titanium alloy bar
Tekijä: Korsunsky, A
Julkaistu: (2006)

The Effect of Transition Metals on Quasicrystalline Phase Formation in Mechanically Alloyed Al65Cu20Fe15 Powder
Tekijä: M. Mitka, et al.
Julkaistu: (2020-07-01)

Strain gradient polycrystal plasticity analysis: Fe modeling and synchrotron X-ray diffraction
Tekijä: Song, X, et al.
Julkaistu: (2010)

Analysis of residual stresses around 'dimpled' cold-expanded holes in aluminum alloy plates
Tekijä: Zhang, S, et al.
Julkaistu: (2008)

The correlation between plastic strain and anisotopy strain in aluminium alloy polycrystals
Tekijä: Korsunsky, A, et al.
Julkaistu: (2002)

Preparation and analysis of quasicrystalline phases by high energy ball milling and X-ray diffraction
Tekijä: Salimon, A, et al.
Julkaistu: (2000)

Crack growth micro-mechanisms in the IN718 alloy under the combined influence of fatigue, creep and oxidation
Tekijä: Prakash, D, et al.
Julkaistu: (2009)

A study of residual elastic strain distribution in an AZ91 Mg alloy bar loaded in four point bending
Tekijä: Prakash, D, et al.
Julkaistu: (2008)

Structure Formation and Corrosion Behaviour of Quasicrystalline Al–Ni–Fe Alloys
Tekijä: O. V. Sukhova, et al.
Julkaistu: (2018-01-01)

Engineering at large scale: Experience from diamond light source
Tekijä: Korsunsky, A, et al.
Julkaistu: (2010)

Residual stresses in rolled and machined nickel alloy plates: synchrotron X-ray diffraction measurement and three-dimensional eigenstrain analysis
Tekijä: Korsunsky, A, et al.
Julkaistu: (2007)

Al62Cu25Fe12 and Quasicrystalline Phases and Their Influence on Oxidation
Tekijä: Lourdes Cristina Lucena A. Jamshidi, et al.
Julkaistu: (2017-03-01)

Synchrotron energy-dispersive X-ray diffraction analysis of residual strains around friction welds between dissimilar aluminium and nickel alloys
Tekijä: Jun, T, et al.
Julkaistu: (2008)

Analysis of plastic deformation and residual elastic strain in a titanium alloy using synchrotron x-ray diffraction
Tekijä: Golshan, M, et al.
Julkaistu: (2005)

Dissipated energy and fretting damage in CoCrAlY-MoS₂ coatings
Tekijä: Kim, K, et al.
Julkaistu: (2010)

Use of XRD technique to investigate the stability of quasicrystalline phase in high-energy milled Al/AlCuFe powders
Tekijä: K.S. Evangelista, et al.
Julkaistu: (2021-11-01)

The influence of punch blunting on the elastic indentation response
Tekijä: Korsunsky, A
Julkaistu: (2001)

Debonding of a weak interface in front of a through-thickness crack
Tekijä: Korsunsky, A
Julkaistu: (2001)

On the size effects and scale transitions in the strength and failure of materials and structures
Tekijä: Korsunsky, A
Julkaistu: (2009)

The Somigliana ring dislocation revisited: 1. Papkovich potential solutions for dislocations in an infinite space
Tekijä: Korsunsky, A
Julkaistu: (1996)

On the use of interpolative quadratures for hypersingular integrals in fracture mechanics
Tekijä: Korsunsky, A
Julkaistu: (2002)

Residual elastic strain due to laser shock peening: modelling by eigenstrain distribution
Tekijä: Korsunsky, A
Julkaistu: (2006)

Residual elastic strains in autofrettaged tubes: elastic-ideally plastic model analysis
Tekijä: Korsunsky, A
Julkaistu: (2007)

Gauss-Jacobi quadratures for hypersingular integrals
Tekijä: Korsunsky, A
Julkaistu: (2014)

The Somigliana ring dislocation revisited: 2: Solutions for dislocations in a half space and in one of two perfectly bonded dissimilar half spaces
Tekijä: Korsunsky, A
Julkaistu: (1996)