The solution of cracks emanating from circular holes

The solution of cracks emanating from circular holes

Dettagli Bibliografici
Autori principali:	Lin, S, Hills, D, Nowell, D
Natura:	Journal article
Pubblicazione:	1996

Documenti analoghi

Crack tip stress intensity factors for a crack emanating from a sharp notch
di: Philipps, A, et al.
Pubblicazione: (2008)

RESEARCH OF OPENING DISPLACEMENTS FOR TWO CRACKS EMANATING FROM A CIRCULAR HOLE IN AN INFINITE PLATE UNDER PRESSURE ON PART OF CRACK SURFACE
di: ZHU QingYu, et al.
Pubblicazione: (2019-01-01)

The analysis of a semicircular crack emanating from a hole in a plate / [mikrofilem]
di: 465466 Browning, William Marcus

EXACT SOLUTION FOR THE CRACK EMANATING FROM THE TOP OF TWO DISSIMILAR WEDGES
di: Tikhomirov Victor
Pubblicazione: (2019-06-01)

Stresses in a flat plate due to a loose pin pressing against a cracked hole
di: Lin, S, et al.
Pubblicazione: (1997)

Crack tip stress intensity factors for a crack emanating from a semi-infinite notch with application to the avoidance of fatigue in complete contacts
di: Philipps, A, et al.
Pubblicazione: (2009)

COMPLEX VARIABLE FUNCTION SOLUTIONS OF MIXED-MODE STRESS INTENSITY FACTORS FOR TWO CRACKS OF ARBITRARY LENGTH EMANATING FROM AN ELLIPTICAL HOLE
di: ZHU QingYu, et al.
Pubblicazione: (2019-01-01)

CURVED INTERFACE CRACKS BETWEEN ELASTICALLY DISSIMILAR MEDIA, WITH APPLICATION TO THE ANALYSIS OF CIRCULAR INCLUSIONS
di: Kelly, P, et al.
Pubblicazione: (1994)

CRACK LINE AND EDGE GREEN-FUNCTION FOR STRESS INTENSITY FACTORS OF INCLINED EDGE CRACKS - DISCUSSION
di: Hills, D, et al.
Pubblicazione: (1993)

THE SOLUTION OF THE CONTACT BETWEEN A TILTED CIRCULAR RIGID PUNCH AND AN ELASTIC HALF-SPACE
di: Munisamy, R, et al.
Pubblicazione: (1995)

Open cracks at or near free edges
di: Nowell, D, et al.
Pubblicazione: (1987)

STRESS INTENSITY CALIBRATIONS FOR CLOSED CRACKS
di: Hills, D, et al.
Pubblicazione: (1989)

CRACK INITIATION CRITERIA IN FRETTING FATIGUE
di: Nowell, D, et al.
Pubblicazione: (1990)

Mode-I Plane Elasticity Problem of Two Asymmetrical Edge Cracks Emanating from an Elliptical Hole in Two-Dimensional Decagonal Quasicrystals
di: Jing Yu
Pubblicazione: (2023-06-01)

Orientation of propagating crack paths emanating from fretting-fatigue contact problems
di: Eugenio Giner, et al.
Pubblicazione: (2016-01-01)

Orientation of propagating crack paths emanating from fretting-fatigue contact problems
di: Eugenio Giner, et al.
Pubblicazione: (2015-12-01)

Comparison of crack closure measurements using moire interferometry and results from a Dugdale-type crack closure model
di: Fellows, L, et al.
Pubblicazione: (1997)

THE EDGE INTERFACE CRACK
di: Kelly, P, et al.
Pubblicazione: (1994)

A theoretical and experimental investigation of the influence of crack tip plasticity on fatigue crack closure
di: Nowell, D, et al.
Pubblicazione: (1999)

Prediction of fretting crack propagation based on a short crack methodology
di: Fouvry, S, et al.
Pubblicazione: (2008)

On the initiation of fretting fatigue cracks
di: Fellows, L, et al.
Pubblicazione: (1997)

PLANE CRACKS NEAR INTERFACES
di: Hills, D, et al.
Pubblicazione: (1989)

Residual stress measurement by the crack compliance technique
di: Tochilin, S, et al.
Pubblicazione: (1998)

Fracture toughness of rough and frictional cracks emanating from a re-entrant corner
di: Andrea Carpinteri, et al.
Pubblicazione: (2017-07-01)

Fracture toughness of rough and frictional cracks emanating from a re-entrant corner
di: Andrea Carpinteri, et al.
Pubblicazione: (2017-06-01)

Information Leakage from Optical Emanations
di: Loughry, J, et al.
Pubblicazione: (2002)

AN ANALYSIS OF COUPLING BETWEEN PLANE CRACKS AND CONTACTS
di: Munisamy, R, et al.
Pubblicazione: (1995)

Surface roughness and crack initiation in fretting fatigue
di: Moobola, R, et al.
Pubblicazione: (1999)

PARTIAL CLOSURE AND FRICTIONAL SLIP OF 3-D CRACKS
di: Dai, D, et al.
Pubblicazione: (1993)

Anti – plane crack emanating from the interface in a bounded smart PEMO- elastic structure
di: B. Rogowski
Pubblicazione: (2013-12-01)

Interaction between a Screw Dislocation and Two Unequal Interface Cracks Emanating from an Elliptical Hole in One Dimensional Hexagonal Piezoelectric Quasicrystal Bi-Material
di: Jiandong Pi, et al.
Pubblicazione: (2022-02-01)

Measurement of residual stresses in beams and plates using the crack compliance technique
di: Nowell, D, et al.
Pubblicazione: (2000)

CALCULATION OF THE OPENING DISPLACEMENT OF SURFACE-BREAKING PLANE CRACKS
di: Dewynne, J, et al.
Pubblicazione: (1992)

Designing against fretting fatigue: crack self-arrest
di: Moobola, R, et al.
Pubblicazione: (1998)

Analytical and numerical modelling of plasticity-induced crack closure in cold-expanded holes
di: De Matos, P, et al.
Pubblicazione: (2008)

THE STRESS-CONCENTRATION PRODUCED BY A HOLE NEAR AN INTERFACE OR JOINT
di: Kelly, P, et al.
Pubblicazione: (1993)

The effect of wear on nucleation of cracks at the edge of an almost complete contact
di: Hills, D, et al.
Pubblicazione: (2010)

The effect of wear on nucleation of cracks at the edge of an almost complete contact
di: Hills, D, et al.
Pubblicazione: (2010)

EIGENSTRAIN METHODS IN 3-DIMENSIONAL CRACK PROBLEMS - AN ALTERNATIVE INTEGRATION PROCEDURE
di: Dai, D, et al.
Pubblicazione: (1993)

THE EVALUATION OF STRESS INTENSITY FACTORS FOR PLANE CRACKS IN RESIDUAL-STRESS FIELDS
di: Wilks, M, et al.
Pubblicazione: (1993)